|
|
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
The manual was complete and of great quality. Originally a tri-lingual file, I first received only one language. After a note to owners-manuals.com, I quickly received the remaining languages... Great service, definitely worth it.
;
Thank you for providing this manual and at low cost.
The Philips scope is of excellent quality, longevity and build and had a couple of faults
when it was passed to me. Having the CCT diagrams is a blessing.
I have fixed the problems and also modded the scope to my requirements.
I have built a 24v Li-Ion pack for portable use from old but good laptop batts.
it is working beautifully and I am well pleased. Keep up the good work Guys.
 ;
manual was very helpful in learning how to propery use my washer. I could not find this manual anywhere else.
;
Awesome quality manual. You really saved my bacon with this one. Was looking for some specific information with regards to my "new" vintage VCR that didn't come with the owners manual. This site is truely a goldmine of available manuals. The quality of the scans are top notch.
Thank-you so much for this awesome manual. If you're looking for this Sony SL-HF400 owners manual, this is the one you NEED to buy. Definitely worth the money.
;
The manual was made available promptly. I is a clean scan of the original. I had no problem downloading it. The scan was well centered and cleanly formatted. It is as good a product as can be had without being the original document.
6
. Measure and cut filler
size. First, measure the distance from inside one window channel to the inside of the other channel and subtract l/4�. Now subtract the width of the air conditioner and divide by 2. This will give you the width to cut each filler board. Be sure to cut the filler boards on the sides opposite the holes. Because the filler boards will be equal in width, they will automatically center your air conditioner in your window.
boards to proper
8
a Place air conditioner
in window by turning unit to one side to get one filler board into window channel (see Figure 36). Now maneuver other filler board into window channel. Reaching through window opening, push filler boards from outside as far toward you as they will go. Be sure to use the foam blocks that are provided. CAUTION: BE SURE UNIT DOES NOT FALL OUT OF WINDOW.
Figure 34
MEASURE DISTANCE FROM INSIDE ONE WINDOW CHANNEL TO INSIDE OF THE OTHER AND SUBTRACT 114�
Figure 36
THE FOAM BLOCKS PROVIDED ARE TO HOLD FILLER BOARD TIGHT AGAINST WINDOW CHANNEL. CUT BLOCKS 114 INCH WIDER THAN CHANNEL AND WEDGE INTO PLACE.
(
i
7 0 Apply
seal strips and attach filler boards. Determine which will be your left and right filler boards. The holes on each board should align with the holes in the side mounting angles. Each filler board should also extend about l/2� above the top edge of the air conditioner cabinet, Now apply 3/8�-wide seal strips on the roomside of each filler board as shown in Figure 35 (i.e. along with bottom edge and window channel edge). Also place a seal strip along the top outside edge of each filler board. Now attach the filler boards to the side mounting angles with the sheet metal screws. Tighten the screws only loosely so the filler boards can be moved back and forth.
9
l
Place side mounting
slides into top mounting
channel. Extend the mounting slides outward into the window channels on both sides (see Figure 37). Pull the air conditioner toward you to position the side mounting slides as far forward in the window channels as possible. Now mark and make a 3/32� pilot hole for each wood screw used to secure the slides in the window channels. CAUTION: BE SURE UNIT DOES NOT FALL OUT OF WINDOW.
Figure 35
1
13
BOARD
|
|
|
> |
|
