SHARP AUA24FF
Owner's Manual

TIMER ON
The unit will turn on automatically according to your setting. Timer duration can be set from a minimum of half an hour (30 minutes) to a maximum of 12 hours. Up to 9.5 hours, you can set in half-hour (30 minute) increments, and from 10 to 12 hours, in 1-hour increments. Point the remote control at the signal reciever window on the unit.

1 Press the TIMER ON (
0.5h 1.0h 1.5h

) button.

� The time setting will change as you press the button as follows.

10h

11h

12h

1

Hold the button down to speed through the setting. � The orange TIMER lamp ( ) on the unit will light. � The unit will generate a beep when it receives the signal. � The time setting will count down to show the remaining time. Select the mode, temperature and fan speed setting as desired.
� When the temperature is set with the TIMER ON, the temperature will show in the display for 5 seconds and then return to the time display. � If you do not change the setting, the unit will operate using the most recent settings. � The unit will turn on prior to the set time to allow the room to reach the desired temperature by the programmed time. (Awaking function)

Display shown when you set the unit to reach the desired room temperature 6.5 hours later.

NOTES ON TIMER SETTING AND OPERATION � The latest time setting will be memorized and will appear on the remote control display the next time you set the TIMER OFF or TIMER ON. � The TIMER OFF and TIMER ON can not be set together. Only the most recent TIMER setting will be valid. � While ONE-HOUR OFF TIMER is set, the TIMER OFF and TIMER ON setting are unavailable. � If the ONE-HOUR OFF TIMER is set while the TIMER OFF or TIMER ON is activated, the TIMER ON or TIMER OFF setting will be cancelled.

13