|
|
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
This is a great manual. It was easy to read and very accurate. The size of the manual is small so email is no problem. I highly recommend it. The manual is very hard to find other than this website.
;
Manual was complete and available promptly, since I had lost my original manual. Very good response.
;
Whilst this is a photo copy, and some of the pages are a little askew, it was all readable and intact. A real bonus finding an old manual for a classic piece of kit that no other site had.
Great stuff.
;
excellent quality, contains circuits and scan quality, 110 pages
;
It was easy done, and I got exactly what I was looking for.
Power and water consumption data: G2P WM1/WH
GB
Programme selector knob
Programme
Temperature
Maximum load ( kg )
Water
Energy
Programme duration ( Min. ) 115 95
HOT / COLD FILL INSTALLATION INSTRUCTIONS
If you wish to connect hot and cold water supply (fig. 1): i) Fix the red marked inlet hose at the hot water tap and at the inlet valve with the red filter on the rear side of the machine. Fix the other inlet hose at the cold water tap and at the inlet valve with the blue filter on the rear side of the machine. MAKE SURE: a) b) The connections are tightly fixed. Do not invert their position (for example: cold fill into hot inlet valve and vice versa).
( °C ) 2 3 Cotton Cotton 95 60
(l) 70 65
( kWh ) 1.90 1.20
5.0
5.0
ii)
6 9 10 11 Synthetic Delicate Wool Silk 60 40 40 30 2.5 1.5 1.0 1.0
60
65 60 70
0.70 0.60 0.50 0.30
80 45 40 40
Programmes with Prewash last approx. 15 minutes longer. The consumption data have been measured in the conditions specified in Standard IEC 60456. Consumption in individual homes may differ from the values given in the table due to variations in the pressure and temperature of the water supply, the load and the type of laundry.
If you wish to connect only the cold fill follow the below instructions (fig. 2): �) You need a Y-piece connector. The Y-piece connector can be ordered via our Service Organization or purchased in a specialized hydraulic component store. �) �) Fix the Y-piece connector to the cold fill tap. Connect the two inlet valves present on the rear part of the machine to the Y-piece connector using the relative provided hoses.
MAKE SURE: All connections are tightly fixed.
cold fill
hot fill
cold fill Y-piece
inlet valve with blue filter
inlet valve with red filter
fig. 1
fig. 2
|
|
|
> |
|
