|
There are currently no product reviews.
 ;
The product was good and just what I needed, however I had moderate difficulty with the down load because the sight would not recognize my pass word. I was finally given a direct link to the manual and that worked.
 ;
Very quick and easy website to use and fast download of manual, quality of manual is excellent and will be pleased to use this service again in the future, thanks so much!
;
It is an very good and clear scanned service manual.
very recommended.
;
Easy to order the manual. Good quality and fast delivery.
;
The Service Manual for Sansui AU-9500 was very helpfull, in complete and in good printable condition.
Thanks.
1
2
3
4
1.3 NOTE ON FL LENS SET
The Sub Panel , FL Lens, and FL Filter are attached to the chassis with two-sided (double-back) tape. If one of these parts has to be replaced, replace all three parts at the same time. To replace the FL Lens, follow the procedures described below:
A
Procedures for replacement of the FL Lens
1. Lightly attach the FL Lens so that the two projections on the upper side of the panel touch the Sub Panel and that the clearances between the OPEN/CLOSE key and the cutout for that key on the FL Lens will be the same on the left and right sides. 2. After confirming that the FL Lens is properly aligned, strongly push the black part of the FL Lens to firmly attach it. Be careful not to press the OPEN/CLOSE key while attaching the FL Lens.
B
Sub Panel
C
FL Lens
OUTPUT RESOLUTION Key OPEN/CLOSE Key
D
E
F
6
1 2
BDP-LX70A
3 4
|
