|
|
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
excellent quality, contains circuits and scan quality, 110 pages
;
It was easy done, and I got exactly what I was looking for.
;
The manuel was exactly what I needed and I received it promptly. Thanks
;
Thanks to Owner-Manuals.com! This manual was exactly what I needed. As Amana was purchased by Maytag and later by Whirlpool, there was no way to receive it from their websites. I was lucky to find this resource.
 ;
Great to be able to set channels again, on an old but stoll fine working TV
SETTING THE CLOCK
(Main unit operation) In this example, the clock is set for the 12-hour (AM 12:00) system.
MEMORY/SET POWER
ON/ STAND-BY
1 2 3 4
Press the ON/STAND-BY button to enter the stand-by mode. Press the CLOCK button. Within 5 seconds, press the MEMORY/SET button. Press the TUNING/TIME (X or display mode.
CLOCK
W) button to select the time
TUNING/ TIME ( )
"AM 12:00" � The 12-hour display will appear. (AM 12:00 - PM 11:59) "AM 0:00" � The 12-hour display will appear. (AM 0:00 - PM 11:59) "0:00" � The 24-hour display will appear. (0:00 - 23:59) q Note that this can only be set when the unit is first installed or it has been reset (see page 15).
2 3
5 6
Press the MEMORY/SET button. Press the TUNING/TIME (X or
W) button to adjust the hour. q Press the TUNING/TIME (X or W) button once to advance
the time by 1 hour. Hold it down to advance continuously. q When the 12-hour display is selected, "AM" will change automatically to "PM".
4
AM 12:00 AM 0:00 0:00
7 8
Press the MEMORY/SET button. Press the TUNING/TIME (X o r minutes.
W) button to adjust the q Press the TUNING/TIME (X or W) button once to advance
the time by 1 minute. Hold it down to change the time in 5 minute intervals. q The hour setting will not advance even if minutes advance from "59" to "00". Press the MEMORY/SET button.
5 6 7 8 9
9
q The clock starts operating from "0" second. (Seconds are not displayed.) And then the clock display will disappear after a few seconds.
To see the time display:
Press the CLOCK button. q The time display will appear for about 5 seconds. Note: q The clock display will flash on and off at the push of the CLOCK button when the AC power supply is restored after a power failure occurs or after the AC power cord is disconnected. If this happens, follow the procedure below to change the clock time.
To change the clock time:
xPress the CLOCK button. yWithin 5 seconds, press the MEMORY/SET button. zPerform steps 6 - 9 above.
To change the time display mode:
xPerform
steps 1 - 2 in the section "RESETTING THE MICROCOMPUTER", on page 15.
yPerform steps 1 - 9 above.
6
|
|
|
> |
|
