AIWA CDCZ117
Owner's Manual

Presetting stations manually
(Manual Memory)

1 Press FNC repeatedly to select the desired band
(FM1, FM2, FM3, AM1 or AM2). 2 Press TUNEi or TUNEk to tune in to a desired station (see �Tuning in to a station,� page 3). 3 Press the desired preset station button until the unit beeps.

MY INFO indicator Smart Job

Note
A newly preset station replaces the station on the same band that was previously stored on that preset station button.

Setting the timer
1 Turn off the unit. 2 Press and hold INFO until �PO� flashes in the
display. 3 Press SEL. 4 Set the time you wish the unit to turn on. � Press TUNEi and turn the Smart Jog to set the hour. � Press TUNEk and turn the Smart Jog to set the minute.

Tuning in to a preset station
1 Press FNC repeatedly to select the desired band
(FM1, FM2, FM3, AM1 or AM2).

2 Press the preset station button on which the desired
station is stored.

Active tuning reception control (ATRC)
The unit automatically suppresses FM noise caused by vehicle movement, and maintains sound quality.

5 Press SEL. 6 Press FNC to select the band. 7 Press TUNEi, TUNEk or the desired preset station
button to select the station.

8 Press SEL. 9 Set the time you wish the unit to turn off following the
same procedure used in step 4.

Using the timer
(My Information)
You can schedule the radio to activate for daily radio programs. The unit automatically turns on and off in Radio mode at the scheduled times.

10 Press and hold INFO until the unit turns off, and
setting is completed. When the unit is on, �MY INFO� appears in the display indicating that the unit is standby for a timer. During the timer-activated tuning, �MY INFO� continues to flash. To cancel the timer standby, press INFO so that �MY INFO� disappears.

Note
� To discontinue the timer setting, press and hold PWR/ MUTE until the unit turns off. � To check the setting, turn off the unit, then press INFO. The unit displays the scheduled turn-on and turn-off times with the appropriate radio frequency. � The unit automatically starts tuning at the scheduled time regardless of the current source mode. When the scheduled program is over, the unit automatically returns to the former source mode. � Timer setting remains enabled even if you turn off the unit, and then turn it on. � However, if you press FNC to change the source mode during timer-activated tuning, the scheduled program is canceled.

ENGLISH

4