|
|
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
This is a good quality scan of the original Service Manual from Nordmende, Germany. Contains the circuit diagram, PCB layout, adjust/tune instructions as well. It is NOT in English but in GERMAN language! That was quite right for my german friend from the lower east side in Berlin.
 ;
Received via e-mail this PDF manual is worth the money. This is a quality scan of a manual in excellent condition and is just as good as having the original manual in hand. I have later seen the original manual and it was printed in colour, but this particular manual is black & white but scan resolution is high end quality! All drawings and pictures are presented in great detail. So, nearly perfect score in my opinion.
If you own the turntable you also should own the manual!
;
I was very satisfied with the service manual I ordered and downloaded. I will definitely buy again from this seller.
;
Great product. Recieved it fast...exactly as advertised.
;
Manuals were delivered promptly and were correct as advertised. No issues with the download link which was provided promptly after everything was processed. Very pleasant experience
1. Tape Interchangeability Alignment
Note: To do these alignment procedures, make sure that the Tracking Control Circuit is set to the preset position every time a tape is loaded or unloaded. (Refer to page 2-3-4, procedure 1-C, step 2.) Equipment required: Dual Trace Oscilloscope VHS Alignment Tape (FL6NS8) Guide Roller Adj. Screwdriver Flat Screwdriver (Purchase Locally) Note: Before starting this Mechanical Alignment, do all Electrical Adjustment procedures.
Flowchart of Alignment for tape traveling Loading (Use a blank tape.) No good Adjust the height of the Guide Rollers (Supply side and take-up side). (Use a blank tape.) (Page 2-3-3) 1-A
Check to see that the tape is not creasing and that there is no slack on the supply and take-up side Guide Rollers. (Use a blank tape.) 1-A Adjust the X Value for maximum envelope. (Page 2-3-3) (Use Alignment Tape.) 1-B
Do the final tape-traveling test to see that the tape runs normally in play mode without creasing or slacking. 1-A OK No good Check to see that the tape is not creasing and that there is no slack on the REV Post. (Use a blank tape.) 1-E OK
Adjust the envelope. (Page 2-3-4) Check the envelope. OK Adjust the Audio Section. (Azimuth Alignment) (Page 2-3-4) Check the audio output. OK Check the following: 1. X Value (Page 2-3-3) 2. Envelope (Page 2-3-4) OK
1-C
1-C
1-D 1-D
No good
Completion
No good Adjust the X value and envelope. 1-B, 1-C
1-B, 1-C
2-3-2
D5P4HSMA
|
|
|
> |
|
