|
|
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
This manual is perfect! Just what I needed. Thanks!
;
This manual was very clear and complete, the prices can't be beat, great to have older manuals available!
 ;
Doubted for buy this manual as it is my first order here and at not have cover image, I assumed would haven't. However, within 24 hs, already possessed the link to download it. The manual are scanned correctly and have all what is needed. Includes adjustments and diagrams of all circuits. Very satisfied.
;
Really good quality, аll readable.! Wonderful work shop. I recommend to all!
;
Good quality service manual.The scheme is on A3 format and very readable.Thank you
Pin No.
36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63 64
Pin Name
LVDD LCHO LVSS RVSS RCHO RVDD MUTER XVDD XOUT XIN XVSS SBSY EFLG PW SFSY SBCK FSX WRQ RWC SQOUT COIN CQCK RES T11 16M 4.2M T5 CS T1
I/O
� O � � O � O � O
Description
Left channel 1-bit D/A converter power supply. Left channel 1-bit D/A converter output. Left channel 1-bit D/A converter ground. Normally, 0V. Right channel 1-bit D/A converter ground. Normally, 0V. Right channel 1-bit D/A converter output. Right channel 1-bit D/A converter power supply. Right channel 1-bit D/A converter muting output. (Not used) Power supply of crystal oscillator. For the connection of a 16.93MHz crystal oscillator.
I � O O O O I O O I O I I input. I O O O I I I LC78622NE reset input. Test output. Set to open (normally, "L" output.) (Not used) 16.9344MHz output. (Not used) 4.2336MHz output. Test input. A pull-down resistor is incorporated. (Connected to 0V) Chip select input. (Connected to 0V) Test input with no pull-down resistor. (Connected to 0V) Ground of crystal oscillator. Normally, 0V. Subcode block sync signal output. (Not used) C1, C2, single, duplex correction monitor. (Not used) Output of subcodes P, Q, R, S, T, U and W. (Not used) Subcode frame sync signal output. Falls when the subcode is set to the standby state. (Not used) Subcode read-out clock input. Schmitt trigger input. ("L" is applied when not used.) (Connected to 0V) 7.35kHz sync signal output obtained by dividing the oscillator frequency. (Not used) Subcode Q standby output. Read/write control input. Schmitt trigger input. Subcode Q output. Command input from the microprocessor. Command input retrieval clock or subcode retrieval clock input from SQOUT. Schmitt trigger
� 22 �
|
|
|
> |
|
