|
|
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
ecelent I was reciver the service manual soon I fell so happy very complete 100% positive all by this store tanks atte Luis salazar
 ;
A great copy of the manual, and the only one I could find anywhere on the net! The circuit diagrams are easily readable, all component values marked and easy to see. A highly appreciated download!
;
Great Manual. This manual is available no where else. It was exactly what I was looking for.
;
The TEAC A-1500's Service Manual was instrumental in reviving this classic reel-to-reel. Not only does it have the schematics, exploded parts diagram and parts list, it also provided mechanical adjustment information that approximate factory default settings.
;
This service manual was determinant to enable to fix my Alpine Amplifier. I am pleased with my purchase. For a 5 star rating I would like to see a higher resolution scan of the printed circuit board lay-out because the gray scale grafics was dificult to see. Also some schematic diagrams were scanned at a slight angle. Never the less, it had all information I needed to troubleshoot and service my equipment.
DV MECHANICAL ADJUSTMENT MANUAL VII
2. 1) 2)
3)
CUE/REV Check Play back the tracking alignment tape (XH 2-1) (Ref. No. J-5). Establish the CUE mode. Confirm that the pitches between the peaks of the RF waveform are equally spaced. Also confirm that the RF waveform amplitude at entrance side (B) and exit side (C) is 50% or more respectively, when taking the amplitude (A) in the CUE or REV mode as 100%. Establish the REV mode. Confirm that the pitches between the peaks of the RF waveform are equally spaced. Also confirm that the RF waveform amplitude at entrance side (B) and exit side (C) is 50% or more respectively.
3. 1) 2)
3)
4)
Rise-up Check Play back the tracking alignment tape (XH 2-1) (Ref. No. J-5). Change the modes from CUE mode to FWD. Confirm that the RF waveform rises up within two seconds when the mode is changed from CUE mode to FWD. Change the modes from REV mode (two seconds or more of REV and to the FWD within five seconds) to FWD. Confirm that the RF waveform rises up within two seconds when the mode is changed from REV mode to FWD. Change the modes from STOP mode to FWD. Confirm that the RF waveform rises up within two seconds when the mode is changed from STOP mode to FWD.
B
C
A=100%
400 µsec B = 50% or more C = 50% or more
Fig. 4-13
� 52 �
|
|
|
> |
|
