|
|
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
as always, rapid and efficient, very good and clear prints
details clearly visible keep going this way!!!!!!
;
I expect a wonderful result as alaways!!!!!!
Usually is much faster....
;
Wow very wonderful and clear!!!! I will always trust them
;
Providing the manual works fine, quickly and without any problems for an acceptable price. After printing the service manual it took me only a short time to repair my carradio from Clarion. Thank You! Greetings from Heiko
;
I was searching a way to modify the original phono-in entry (for connection of vynil disc player, with RIAA equalization) to a line-in entry (for connection of modern analog entries, eg. ipod, mp3player).
This service manual gave me the correct hints.
It contains very useful infos for repairing and modifing the hi-fi, such as disassembling instructions, block diagrams, schematic diagrams, PCB prints, replacement parts list.
Very good!
DCR-PC109/PC109E
ENGLISH
2. POWER SUPPLY DURING REPAIRS
JAPANESE
In this unit, about 10 seconds after power is supplied to the battery terminal using the regulated power supply (8.4V), the power is shut off so that the unit cannot operate. This following two methods are available to prevent this. Take note of which to use during repairs. Method 1. Use the AC power adaptor. Method 2. Connect the servicing remote commander RM-95 (J-6082-053-B) to the LANC jack, and set the commander switch to the �ADJ� side.
3.
1 2 3 4 5 6 7 8 9
TO TAKE OUT A CASSETTE WHEN NOT EJECT (FORCE EJECT)
Remove the front panel section and cabinet (R) section. Remove the cabinet (upper) (G) assembly. Remove the lens section. Remove the rear panel assembly and control switch block (SS6800). Remove the EVF section. Open the VC-352 board. Remove the mechanism deck and the VC-352 board. Disconnect CN9102 (27P, 0.3mm) of VC-352 board. Supply +4.5V from the DC power supply to the loading motor and unload with pressing the cassette compartment.
Loading motor Disconnect the flexible board from CN9102 of VC-352 board.
CN9102
DC power supply (+4.5Vdc)
VC
-3
5
2
VC-352 board
1-2
|
|
|
> |
|
