|
|
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
Very easy site. Great service and quick release for download. Manuals are of good quality.
Joop - The Netherlands
;
Very good manual, in depth and complete. Only criticism is that some of the circuit diagrams are slightly blurry and hard to follow for long periods of time, but this is to be expected. Perfect for any maintenance required. Also contains the wiring diagrams of the control cable for constructing extensions.
;
Received a quick response, material was exactly what it was supposed to be. The service did everything I expected it to do. would use service again.
;
Detailed SONY CFD980 Service Manual at an easy to find one stop shopping. Make my radio hobby technically interesting. Thanks.
 ;
Excellent service from Owner-Manuals.com, good prices and quick turn around. The supplied PDF was good enough quality to be enlarged sufficiently to read component values.
10-356 Sub Heater On Time
The Sub Heater remained on for more than the specified time.
Procedure
Turn off the power, remove the Fuser Assembly. and allow it to cool down. Measure the resistance between P/J600-7 and P/J600-9 on the Fuser Assembly. The resistance is between 30 and 190 K OhmÃs. Y N Check the Rear Thermistor for an open circuit and poor contact. If the check is OK, replace the Sensor Assembly (PL 7.2). Measure the resistance between P/J600-3 and P/J600-12 on the Fuser Assembly. The resistance is 20 OhmÃs or less. Y N Replace the Fuser Assembly (PL 7.1). Reinstall the Fuser Assembly, turn the power on, enter dC140 [010-101]. The display is between 678 and 699. Y N Turn the power off. Check for an open or poor connection between P/J404-13 on the MCU PWB and P/J600-7 on the Fuser Assembly. If the check is OK, replace the MCU PWB (PL 13.1). There is Line Voltage measured at FS47 on the AC Drive PWB (PL 9.2). Y N There is +5VDC measured at P/J590-3 on the AC Drive PWB (PL 9.2). Y N Check the wires and connectors. If the check is OK, replace the MCU PWB (PL 13.1). There is +24VDC measured at P/J590-1 on the AC Drive PWB (PL 9.2) Y N Check the wires and connectors. If the check is OK, replace the MCU PWB (PL 13.1). Replace the AC Drive PWB (PL 9.2). Check the wires and connectors. If the check is OK, replace the Fuser Assembly (PL 7.1).
Figure 1 Fuser Front and Rear Thermistor CD
Status Indicator RAPs
6/02 2-190
Prelaunch Training/Review DC1632/2240
10-356
|
|
|
> |
|
