|
|
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
very good quality readable manual,printed off very well.
;
The manual was very accurate for the part that I was changing, I was able to order the correct part and had no issues with the replacement procedure. However, I was expecting to have more detailed repairs for the lower drive unit.
 ;
I needed the manual immediately and I got it immediately. I couldn't find this manual anywhere else on the net. The site was easy to traverse, and the price was very reasonable. I'll definitely be back for any future needs.
;
I received a good service manual, with good resolution. Improve the instructions for the purchase because they are not well understood.
For the rest, so good.
Thanks Angel.
;
Very good documentation for the Grundig 2077 model (as well as similar 800/900/1000 series radios). The first two pages are a summary of reception specifications and output capability. The third page is the tuner dial indicator and dial cord routing diagram. the final ~5 pages are the schematics for the various models (including 2077). The scan quality of the schematics are good, adn can be easily read if zoomed in. The documents are in German, not English as stated. It would have been nice to have the tuning sequence and settings, and some trouble shooting materials... or component and wiring map.
3.1.3 Remove the mechanism assembly (See figure 5) � Prior to performing the following procedure, remove the cover. � There is no need to remove the front panel assembly. (1) Disconnect the socket wire from connector CN451 on servo control board. (2) Disconnect the card wire from connector CN2201 on digital board. (3) Remove the four screws C attaching the mechanism sembly.
top
Mechanism assembly Digital board C C
the the as-
CN2201 C
3.1.4 Remove the digital board (See figure 6, figure 7) � Prior to performing the following procedure, remove the top cover. (1) Disconnect the card wire from connector CN2201 on the digital board. (2) Remove the four screws D and E attaching the digital board. (3) Remove the one screw F attaching the jack board. (4) Lift the digital board up, and remove it. Then, the digital board is removed from the connectors CN4101, CN4102 on the main board. In attaching the digital board, insert the connector on the digital board in these connectors securely.
CN451 Fig.5 E
C
Jack board
F
D
D
Digital board Digital board
E
CN2201 Fig.6 CN4102
CN4101 Main board Fig.7
1-8 (No.XA019)
|
|
|
> |
|
