|
|
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
Some of the pictures in this manual are a bit irritating. I had to dissassemble the unit and some of the screws have different threads, which is not mentioned in this manual. Also some of the drawings of the boards look different than the actual boards.
After all, the manual was very useful. I was able to recalibrate the capstan drive and it is working fine again.
 ;
This manual is very good. 303 pages scanned in a very high resolution. My camera has bad, leaking capacitors which all of the V5000 models are suffering from these days.
There is a huge part list with all capacitors, transistors etc. in this manual which helped me a lot. Otherwise I would not have been able to buy replacement parts.
The dissassembly guide is very enormous and detailed. Unlike on the Panasonic MS1 manual I downloaded here it actually looks like the real parts look. And the screws are labeled correctly, so you shouldn't have any left after the repair. ;)
;
has all the schematics you could need,and very well laid out format also has all part numbers along with an exploded view which is helpful
;
Very nice to have! Now it is no problem to understand how it is put together.
Helps me a lot.
;
good scans, all is clear. all pages in order. recommended
ALIGNMENT INSTRUCTIONS
3. VERTICAL SIZE
* The VERTICAL CENTER adjustment has to be done in advance. 1) Apply a RETMA PATTERN Signal. 2) Set the TV to Normal I mode. 3) Adjust the VERTICAL SIZE of the picture with the select V.size by volume UP/DOWN keys.
4. VERTICAL S-CORRECTION ( Fixed : Adjust if need be )
1) Apply a CROSSHATCH PATTERN Signal. 2) Adjust the S-CORRECTION to obtain the same distance between horizontal lines with the S.Curve by volume UP/DOWN keys.
5. HORIZONTAL CENTER
1) Apply a RETMA PATTERN Signal. 2) Adjust picture centering with the select H.Center by volume UP/DOWN keys.
EW 1. WIDTH
1) Apply a RETMA PATTERN Signal. 2) Adjust the horizontal width to make a perfect circle with the select H.Width by volume UP/DOWN keys.
2. PARA
1) Apply a CROSSHATCH PATTERN Signal. 2) Adjust the vertical line to straight with the select E.W Para by volume UP/DOWN keys.
3. CORNER ( Fixed : Adjust if need be )
1) Apply a CROSSHATCH PATTERN Signal. 2) Adjust the vertical line to straight with the select EW.Cor T by volume UP/DOWN keys.
1) Apply a CROSSHATCH PATTERN Signal. volume UP/DOWN keys.
4. SYMMETRY ( Fixed : Adjust if need be )
2) Adjust the symmetrical balance to be suitable with the select EW Sym by
8
|
|
|
> |
|
