I am very happy with the owner's manual. I bought a used Casio and was so relieved that I was able to get a hold of a owner's manual. It was very easy to download the manual and I had no problems with printing it. Thank you! Nancy Whalen
great site, the most easy and fastest way to find the manual you need, no 5 star because the manual was only available in german, but I speak german as well so no problem for me.
Text excerpt from page 8 (click to view)
Installation
Mounting accessories included
1 deflector 1 chimney support (3 pieces to assemble) 4 metal screws 4 x 8 (to assemble the chimney support) 4 metal screws 3,5 x 9,5 (to affix the deflector to the support) 1 1 6 6 2 reduction flange � 125-120 mm support bracket wood-screws 5 x 45 mm (for wall mounting) wall plugs � 8 mm (for wall mounting) metal screws 2,9 x 6,5 (for upper chimney
G
X
=
=
X
H
mounting) 1 allen spanner (for TORX screws)
Wall unit mounting - Fig. 6-7
Assembling the chimney flue support/bracket (3 parts): The three parts should be fixed with 4 screws, the support extension is adjustable and should correspond to the internal width of the telescopic chimney flue. Fig. 6. � Sign the wall with a center line, this will aid mounting procedure (1), position the template so that the mid line printed on the template matches with the center line previously signed, the lower side of the template corresponds to the lower side of the hood once mounted (2). � Drill two holes � 8mm and fix the support bracket with two wall plugs and screws (3). Hang the hood (4) and adjust its position (5-6). � From the inside of the hood sign two points for definitive fixing (7). � Remove the hood (8) and drill two holes � 8mm (9), fit two wall plugs (10). � Drill two holes � 8mm on the upper side close to the ceilling, fit two wall plugs (11) (In case the hood is to be used in filter version, mount the deflector F on the chimney support with four screws and fix the chimney support G with two screws (12). � Hang the hood again (13) and fix it definitively with two screws (14). � Fit an exhausting pipe (15) to connect the outlet hole A of the hood to the outside (Extractor hood) or to the deflector F (Filter version). � Make electrical connection (16). � Fix the chimney first up (17a) to the chimney support (17b), then slide the lower section of the chimney down into the proper housing on top of the hood (18).
