|
Who's Online
There currently are 6037 guests online.
|
Categories
|
Information
|
Featured Product
|
|
|
|
|
There are currently no product reviews.
;
I've looked some time for this manual, you guys had it and to a good price. A++++
;
factory technician level - complete with board views :
( removing chassis from cabinet , only thing missing ) ;
on weekends , staff is not available so - be patient .
;
Good complete Service-Manual (SONY PVM6041QM)
A few graphics and waveforms not very clear! (-1*)
;
Excellent manual. In addition to the information I needed was a complete description of both electronic and mechanical devices.
Excellent site.
Thank you very much.
;
very good and complete manual , it is in english and german is perfect for repair.
IC DESCRIPTION IC, TMP04CH00F350
Pin No. 1 2, 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 Pin Name V1 C1, C2 VSS VXT BRESET XLIN XLOUT VDD XHIN XHOUT TEST BUZZER OUT BUCK UP JOG IN1 JOG IN2 FAST KEY SET KEY SLEEP KEY SNOOZE KEY DAY KEY I/O O � � O I I O � I O I O I I I I I I I I H: JOG UP/DOWN is set to 10 minutes by one click. L: JOG UP/DOWN is set to 1 minute by one click. Sets the time, cancels the alarm and starts the date setting mode. Used to set the sleep setting and to check the remaining time. Cancels the alarm by every 5 minutes and cancels sleep. Sets and cancels the summertime. And toggles between the alarm display and date display. 22 ALARM IN 1 I H: When the ALARM mode switch is in the 1, or 1 + 2. L: When the ALARM mode switch is in the 2. 23 ALARM IN 2 I H: When the ALARM mode switch is in the 1 + 2 or 2. L: When the ALARM mode switch is in the 1. 24 ALARM IN 3 I H: When the POWER switch is in ALARM. L: When the POWER switch is in ON or STANDBY. 25 26 27 28 29 30-89 90-97 98-100 ALARM IN 4 POWER ON POWER OUT EL 24H IN S1-S60 COM1-COM8 V4-V2 I I O O I O O O H: When the ALARM function switch is in the BUZZER position. L: When the ALARM function switch is in the RADIO position. Recognizes the POWER (RADIO) ON/OFF. H: RADIO output. L: STANDBY state. When any key input (short pressing) is present, �H� is outputted for 5 seconds. Or �H� is continuously outputted when the SNOOZE key is pressed for a long time. H: 24H. L: 12H. LCD segment output. LCD common output. Stepped-up voltage output. TEST input. Outputs the buzzer signal when it reaches the alarm time. H: Normal state L: Backup mode (Power off state). See Note. Modification of the time shall be made by the JOG spec. Power supply (+). Terminal to which external crystal/resistor for high-speed oscillation is connected. Regulator-2 output. Capacitor terminal for LCD step-up voltage. Power supply (�). Regulator-1 output (It is outputted in 3.0 V type only). Reset input (active at low). Terminal to which external crystal for low speed oscillation is connected. Description
Note: In the BACKUP mode, the present time and the ALARM time setup are kept alive while the other functions are turned off (LCD is also turned off).
11
|
|
|
> |
|