|
|
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
Correct manual received and of good quality but the contents of the file for the Service Manual for the same monitor is for a 20" TV not the RGB Monitor.
;
The owners manual for the Pioneer VSX-D603S was exactly what I needed. I received it in a timely manor and it was priced fairly. I definately will use your servise again. Thank You
;
This is a great manual. It was easy to read and very accurate. The size of the manual is small so email is no problem. I highly recommend it. The manual is very hard to find other than this website.
;
Manual was complete and available promptly, since I had lost my original manual. Very good response.
;
Whilst this is a photo copy, and some of the pages are a little askew, it was all readable and intact. A real bonus finding an old manual for a classic piece of kit that no other site had.
Great stuff.
Clock/Timer
Press CD, TUNER or TAPE to select the desired source. G Before setting the timer, make sure the music source has been prepared. CD � Load the disc(s). To start from a specific track, make a programme (refer to �CD Operation - Programming the disc tracks�). TUNER � tune to the desired radio station. TAPE � load the prerecorded tape into tape deck 2. 3 Press à or á on the system repeatedly to set the hour for the timer to start. 4 Press à or ë on the system repeatedly to set the minute for the timer to start. 5 Press CLOCK�TIMER to store the start time. � "TIMER ON" will be displayed and followed by the set timer "XX:XX" and then the selected source. � TIMER will remain on the display. G At the preset time, the selected source will play. To exit without storing the setting G Press �on the system. Notes: � If CD is the selected source and it is not available when the preset time is reached, Tuner will be selected automatically. � During timer setting, if no button is pressed within 90 seconds, the system will exit timer setting mode automatically. To deactivate the TIMER G Press TIMER ON/OFF on the remote control. � The display will show "CANCEL" and TIMER will disappear from the display. To activate the TIMER G Press TIMER ON/OFF on the remote control. � The last set timer information will be shown for a few seconds and TIMER will appear on the display.
2
Sleep Timer Setting
The sleep timer enables the system to switch to Standby mode automatically within a preset amount of time.
E n g l i s h
1
2
Press SLEEP on the remote control repeatedly to select a preset amount of time. � The selections are as follows (time in minutes): 15 � 30 � 45 � 60 � OFF � 15 � � "SLEEP XX" or "OFF" will be displayed. "XX" is the time in minutes. When you reach the desired length of time, stop pressing the SLEEP button. � SLEEP will appear on the display, except for "OFF" mode. � The Sleep Timer is now set. Before the system switches to standby mode, a countdown of 10 seconds will be displayed. "SLEEP 10" � "SLEEP 9".... � "SLEEP 1" � "SLEEP" While SLEEP mode is activated
To check the remaining length of time G Press SLEEP once. To change the preset sleep timer G Press SLEEP twice. � The display will show the remaining time followed by the sequence of sleep timer options. To deactivate the Sleep Timer G Press SLEEP repeatedly until "OFF" is displayed, or press the STANDBY ON button.
24
pg 001-027/C788/21-Eng 24 12/11/01, 5:29 PM 3139
115 21171
|
|
|
> |
|
