|
|
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
This Service manual is very well scanned and its clean to read, no any anti-theft words that un-english could understand. I got my CCD600 working with this manual and it´s clear shematics :)
;
I was very pleased with the service provided and was surprised at how good the quality was of the manual. I thought it may be a third generation copy or so, but it is as good as the websites that charge 3 times this much. I repair some electronics for family and friends without charge, so this is perfect for me. Thank you very much.
;
The service was great and the document was also great. Highly recommend!!!!
If anyone has a users manual... Please email me. need one. $ [email protected]
;
I needed a service manual as the display on my oscilloscope was very dim. I thought I'd give owner-manuals.com a try, as they advertised a huge number of manuals. Sure enough they had one listed. I bought it hoping it would be useful... actually, I bought it hoping it would be readable! I've had manuals from online sources in the past, and been very disappointed. Not this time! An excellent manual, complete, and very readable. Using it I fixed my 'scope, and as such the manual was an investment that paid off manyfold. Do I have any complaints? One very minor one - The circuit diagrams could have been scanned at a higher resolution, as some of the details were a little difficult to make out - not impossible, just not as easy as my old eyes would like! Overall, I'm very satisfied with my manual, and I will certainly be using this company again. Well done.
 ;
I Have looked for this manual for quiet a while now, I have finally found it here. I believe this is the only place they have them in a very nice scan, pages are very clear to read, some of the pages are a bit tilted but overall it is great to have this manual available for purchase. Thanks
5
6
7
8
6) RF level automatic adjustment (RFAGC)
This adjustment is performed in order to adjust variation of RF signal (RFO) level to fixed value and to realize reliable signal transmission. The adjustment is performed with changing amp gain between RFI and RFO. Adjustment steps (1) The microcomputer reads out output from RF level detect circuit inside servo LSI by a command. (2) The microcomputer calculates desired RFO level of amp gain volume from read value. (3) The microcomputer sends an appropriate command to servo LSI to reach to the gain volume of (2). This adjustment is performed at the following timing, � During set-up, only focus-close is finished � At the point of set-up completion (just before playing) � During playing, after recovering from out-of-focus 7) Adjustment of gain of preamp stage If there is lens dirt, or reflected light of a disc is notably small during CD-RW replaying, gain of entire RFAMP(FE, TE, RF amp) should be +6dB, +12dB according to the situation. Adjustment steps When reflected light of a disc is notably small during setup, the entire RFAMP should be +6dB, +12dB. In addition, when changing gain, perform again the set-up procedure from the start. When it is considered that "the entire gain of RFAMP is always played at +6dB", perform the set-up at +6dB in advance from the next time. See the figure below.
A
B
Entire RFAMP GAIN Playing with +12dB gain with CD-RW, etc. + 12dB
C
+ 6dB
D
Detecting that "lens is dirty" and playing with +6dB from the start TYP
+6dB play increases because of dirt of lens, etc. (Set-up starts with TYP gain.)
Fig.14 Conceptual diagram of gain of preamp stage
Time
E
F
CX-3168
5 6 7 8
13
|
|
|
> |
|
