KENWOOD HM-DV6
Owner's Manual

Basic use method

21

Muting the sound temporarily
Remote control unit only

Bass and treble compensation (NB : Natural Bass circuit)
Blinks
SOUND
MUTE
URROUND P.S.A. NB 1 2 MHz kHz

MUTE

÷ Press again to resume the original volume. ÷ This is also cancelled when the volume is changed.

Each press switch the modes as follows. 1 "NB 1" (Only the lowest frequencies are enhanced.) 2 "NB 2" (The lowest and highest frequencies are enhanced according to the current volume level.) 3 "NB OFF" (The source signal is processed by the tone control circuitry before being output from the main unit.)

Tone adjustment
Remote control unit only

The responses of the lowest frequencies (BASS) and highest frequencies (TREBLE) can be adjusted as desired.After this adjustment, the N.B. effect will be disabled.

Balance adjustment
The balance of volumes from the left and right speakers can be adjusted as follows.

1 Press the TONE key to select "BASS".
Adjust the level of lowest frequencies as desired using the VOLUME keys.

1 Press the MODE key.
TONE

\

5
VOLUME

�

2 Turn the VOLUME/MULTI CONTROL knob
to select "BALANCE", then press the SET/ DEMO key.

2 Press the TONE key again while "BASS" is
displayed to select "TREBLE". Adjust the level of the highest frequencies using the VOLUME keys.

3 Adjust the left and right speaker balance by
turning the VOLUME/MULTI CONTROL knob.

TREBLE
3 Press the TONE key.

+4

L--4 Press the SET/DEMO key

--R

Basic section

÷ The "BASS" and "TREBLE" can be adjusted independently in the range from "- 8" to "+ 8".