|
|
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
Superb! It's the original manual. We can now use our old calculator with its full function.
;
This is a very well written and comprehensive manual. It answered all our queries.
;
Excellent copy that was delivered within 12 hours and solved my problem.
 ;
I did not have the manual for a Whirl Pool gas dryer, therefore I purchased it from Owner-manuals. This is exactly what I needed. Thank you for the service.
;
I was so pleased to get the owner`s manuel within one hour! Thanks again.
Regards
Werner
SOUND ADJUSTMENTS
Performing the basic sound settings
You can set the speaker output balance, subwoofer output level, and input level of each source. � There is a time limit in doing the following procedure. If the setting is canceled before you finish, start from step 1 again.
2
Adjust the level.
To adjust fader and balance�Fad, Bal: Make these two adjustments at the same time. � If you are using a two-speaker system, set the fader level to �00.� � Press 5 (up) or � (down) to adjust the fader. � Press ¢ or 4 to adjust the balance.
1
Press SEL (select) repeatedly to show one of the basic sound setting (SEL) screens.
SEL
Each time you press the button, the adjustable items change as follows:
DSP
iEQ
Basic sound settings
Fad/Bal
To adjust subwoofer output�Sub Out: This takes effect only when a subwoofer is connected.
ATT
Canceled
Vol Adj
BBE
Sub Out
To increase the level. To decrease the level.
� For DSP mode settings, see pages 32 to 34. � For iEQ (sound mode) settings, see pages 35 and 36. Indication Fad To do: Range
Adjust the front R06 (Rear only) and rear speaker | balance. F06 (Front only) Adjust the left L06 (Left only) and right speaker | balance. R06 (Right only) Adjust the subwoofer output level and cutoff frequency level. Make sounds natural. Adjust and store the input level of each source. 00 (min.)
|
You can also set an appropriate cutoff frequency level according to the subwoofer connected. � Press ¢ or �Mid,� or �High.� Low: 4 to select �Low,�
Bal
Sub Out
08 (max.) Low/Mid/High BBE Off, BBE 1, BBE 2, BBE 3 �05 (min.)
|
BBE Vol Adj
Frequencies higher than 50 Hz are cut off to the subwoofer. Mid: Frequencies higher than 80 Hz are cut off to the subwoofer. High: Frequencies higher than 115 Hz are cut off to the subwoofer.
+05 (max.)
37
ENGLISH
|
|
|
> |
|
