|
|
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
Absolutely perfect! I've been trying to understand how to use all or at least some of the features of the receiver and especially the remote.
;
Copy of genuine owners/operators manual, very useful
;
The manual was a perfect match and was exactly what I was looking for. I'm very satisfied with my purchase.
;
Thank you for having the manual I needed for an older model Aiwa stero I had found on Ebay --- I wanted the Aiwa because I had tapes and cd's but I did not have a manual as to how to operate the system... I found what I needed and it has enabled me to set the system up for my enjoyment.
;
I wished detailed information of the JBL S310 and here I found it! Very happy with the service from this site!
Troubleshooting Guide
PROBLEM
No sound can be heard, or the volume is low.
POSSIBLE CAUSE
Attenuator is turned on. The fader or balance settings are set all the way to one side. The input/output wires or wiring harness are connected incorrectly. The cassette tape is bad. The values of Volume offset are low. Turn off Attenuator.
SOLUTION
Reset the fader or balance settings. Reconnect the input/output wires or the wiring harness correctly. See the section on "Connecting Wires to Terminals". Try playing another cassette tape. If works fine, the first tape was bad. Increase the values of Volume offset. (see p. 7) Press the Eject button.
The tape does not go in. / No sound can be heard even though the tape display is made. The sound quality is poor or distorted.
The car ignition was turned off during tape eject; or the tape was pulled out during loading, switching the mode to tape mode even though no tape is in. The tape head is dirty. One of the speaker wires is being pinched by a screw in the car. The speakers are not wired correctly.
Clean the tape head, referring to the section on "Cleaning the tape head" (see p. 4). Check the speaker wiring. Reconnect the speaker wires so that each output terminal is connected to a different speaker. The tape can only be removed within 10 minutes of the ACC switch being turned OFF. If more than 10 minutes has elapsed, turn the ACC switch ON again and press the Eject button.
Can�t remove tape.
The cause is that more than 10 minutes has elapsed since the vehicle ACC switch was turned OFF.
� 41 �
|
|
|
> |
|
