|
|
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
It is perfect, exactly what we needed. It's like the paper version but less clutter.
 ;
Received my manual within 24 hours. Very clear scan of the manual I needed. Thanks!
;
Very clear scan, I recommend it. Definitely a must have for any 3362 owner.
Alpine could have written a slightly more complete manual, though. It's already pretty huge, but the unit has so many functions, I feel some more explanation would have been better.
Yamaha's manual of their comparable YDSP-1 is a little better in my opinion.
;
Immediate response with excellent service - highly reccommended
;
Correct manual received and of good quality but the contents of the file for the Service Manual for the same monitor is for a 20" TV not the RGB Monitor.
6. Maintenance
Cleaning Caution
AV Mute Source Menu OK
>
Switch off and disconnect the projector before cleaning. 1 Press the Standby button twice to switch off the projector. � The Standby indicator starts blinking orange. 2 Wait until the cooling fan has stopped (about 3 minutes after the projector has been put in Standby) and disconnect the mains lead and all other cables. Cleaning the cabinet � When the cabinet is dusty, clean it by gently wiping with a soft cloth. � A chamois leather slightly moistened with water is sufficient for cleaning the housing. � Do not use cleaning agents as they may harm the housing. Cleaning the lens � When the lens is dirty or dusty, first blow the dust off and then gently wipe with a soft brush or lens cleaning paper. Never touch the lens with your fingers. � The lens is likely to become mouldy if left dirty. Cleaning the dust filter Make sure to clean the dust filter regularly. 1 Switch off the projector and wait until the cooling fan has stopped before disconnecting the 2 3 projector. Turn the projector over. Never place the projector on the side where the connections are located! Press tab A and remove filter holder B from the projector.
Lamp Stand by Temp
Important
A B
4 5 6 7
Press clamp C, open the holder and remove the filter. While firmly holding the filter, gently remove any accumulated dust, from the dusty side, with a vacuum cleaner. Press clamp C, put the filter back in place and release clamp C. Firmly press the filter edges in place. Close the filter holder.
C
A B
C
8
Press tab A and insert the filter B into the projector.
Notes
We advise you to clean the filter every 100 hours. Operating the projector without filter or with a torn or damaged filter may seriously damage the projector. When the filter is damaged replace it with a filter of the same type (12 nc: 3122 434 0157 0). The projector power cannot be switched on again unless the filter holder is installed correctly.
Philips Home Cinema Projector
English User guide Garbo
27
|
|
|
> |
|
