|
|
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
- Very good scan quality, PERFECT!
- Sehr gute scan Qualitaet, empfehlenswert!
Wolfgang Sundhaus
 ;
Good site, works ok and you get what you order, no problems experienced, got my manual within a day. A++++
;
Original well scanned manual. Got the job done. Microwave problem found & corrected. For $5 and a new magnitron from ebay, it was a cheap and good the first shot fix. Electrical schematics allowed me to mage sure every thing else was ok before cutting and order for parts. Hard to live without.
;
I was very skeptical of this website, I have never downloaded manuals before. I put it on the AMEX and payed through Paypal to ensure protection. I got the manual exactly as described and now I can replace the filter capacitor for this amp. Great Price, others selling for 12.99 or more and this is the same manual. I will search out this website for other manuals. Thank you
;
Manual was reasonably easy to follow. I am not an engineer or know much about electronics but with the manuals help I was able to figure out the problem, identify the part required for the repair. Replacement part cost around $30. Whilst replacing the part I was telling myself, "this aint gonna work cos it seems far too easy". Took about 15 minutes to do and my plasma TV works a treat. Would never have been able to do this without the service manual.
M-10X
7.2 CIRCUIT DESCRIPTION
Use a wide range linear circuit of A-607R series for voltage stage, and use HEX POWER MOSFET for output stage.
This circuitry eliminates source resistance, and reduce power loss in large amount with super low capacity resistor of output stage device and realize the low generation of heat, low source voltage. This circuitry eliminates source resistance and listing electric coil, and achieve the damping factor that is flat with band (20Hz - 20kHz).
�B2 +B1 +B2
�B1
8. PANEL FACILITIES AND SPECIFICATIONS
PANEL FACILITIES (The illustration shows the KU/CA type.)
2 3
STEREO POWER AMPLIFIER
v¿,?m
�
STANDBY
STANDBY/ON
POWER
OFF ON
REFERENCE STEREO POWER AMPLIFIER
1
4
NOTE: The protection function will operate in case of internal amplifier malfunction or in case of external causes such as static electricity or speaker terminal short circuits. When the protection function operates, the POWER indicator flashes, and the unit goes out into standby mode. If this occurs, check the speaker terminals and speaker cords to make sure they are not shorted, then press the STANDBY/ON button to turn on the unit. If the protection function then operates again, unplug the power cord and contact a service center.
1 Main power ( � OFF/ _ ON ) button
If the button is OFF (�), the power of the amplifier is shut off and the STANDBY/ON button on the amplifier does not function. Pressing the main power button will turn the amplifier ON (_).
2
STANDBY/ON button
Press to switch the amplifier ON or into STANDBY mode.
3 STANDBY indicator
Lights when the amplifier is in STANDBY mode. (Please note that this amplifier consumes a small amount of power (1 W) during the standby mode.)
4 POWER indicator
Lights when the power is switched on.
21
|
|
|
> |
|
