|
|
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
The manual was missing 2 pages but when I presented the problem to the company they made every attempt to get the 2 pages to me, when they couldn't they refunded my money. A very pleasing and easy transaction. The manual they provided was the original, it was concise and to the point. I plan to do business with this company again when should the need arise.
 ;
The owners manual is very good. all my how to questions were answered in detail.
;
Irrespectively of this manual exist only germany language, it's useful - although i need some additional task to translate: My english is bad, but usable - but i really dont speak germany. :)
;
Excellent service from this company (including a total refund on an earlier purchase when through no fault of the company the manual was incomplete). I have purchased several manuals which I have been very satisfied with, as I am with this one. Highly recommended.
;
It was easy to order and received exactly what I needed. Only complaint would be the 24 hours you have to wait.
CONNECTING AND OPERATING
HOW TO OPERATE IN SEPARATE CONNECTION MODE
2
5
1
4
You should begin with the power switched off.
1.
TURN THE OPERATION MODE SWITCH TO �SEPARATE� Make sure the power is switched off. If the power is on, the warning circuit will be activated, the mode illumination light and mode indicator will flash, and there will be no sound. TURN THE POWER ON Check to see that the word SEPARATE on the mode indicator has lit up. Note that it will not light up if the illumination button is switched off. ADJUST THE VOLUME ON THE CONTROL AMPLIFIER You should refer to the Directions for Use which came with the control amplifier.
2.
3. 4. 5.
USE THE ATTENUATOR DIAL TO ADJUST THE HIGHFREQUENCY CHANNEL VOLUME (0 to -15.0 dB) If you are not using the attenuator circuit, you should press the ATT THROUGH button for at least two seconds. The ATT THROUGH button will light up, and the sound will emerge after a delay of five seconds. SWITCH THE ATT HOLD BUTTON ON The ATT HOLD indicator will light up, and the adjusted attenuation will be held. If you wish to switch from ATT HOLD to ATT THROUGH, you should first switch the ATT HOLD button off, then press the ATT THROUGH button for at least two seconds.
15
OPERATION
|
|
|
> |
|
