|
|
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
Good scan of the original service manual. All schematics and adjustment procedures are there. It helped me to fix a long lasting problem with the tracking circuitry. The manual also includes the supplementals 1,2 and 3. Included are; electrical schematic's , pcb layout's, mechanical drawing's and exploded views, disassembly manual and maintenance procedures. 236 pages.
 ;
The Service Manual received was helpful. The electronic information is exactly what I needed.
I recomend all of my friends about this technical page.
 ;
High quality scan of service manual. I am satisfied!
 ;
Excellent copies.
I will use "Owner Manual" again a second time.
 ;
Very good manual for Technics SL 303. Manuale molto utile.
SECTION 3 ELECTRICAL ADJUSTMENTS
Notes: 1. These adjustments are performed in the order that they are discribed. 2. Adjustment and measurement are performed for each channel unless otherwise specified. 3. Adjustment is made for right channel first and then the left channel. 4. The power voltage at the headphones section is supplied with 1.2 V. 5. The processor section is used as jig to adjust the headphones section (MDR-IF5000). 6. Adjustment is made with the RX SW board and RX PD1 and RX PD2 boards (for both L-ch and R-ch) connected to the RX board with wires (normal part). Adjustment Location:
� RX board (component side) �
TP9 TP11
0 dB=0.775 V
Tuning Adjustment Preparation:
processor (DP-IF5000) headphones (MDR-IF5000)
TUNING ADJUSTMENT (R-ch) L54 L55 TUNING ADJUSTMENT (L-ch) L34 L35
1. Set the processor section (DP-IF5000) in test mode and operate the set to generate a signal of 1 kHz and �10 dB. (Refer to DP-IF5000 service manual page 7.) 2. Supply 1.2 V to between VCC and ground on the RX board. 3. Adjust RV11 (volume control) on the RX board to the minimum level. Setting:
distortion meter
RX board TP11 (L-ch) TP9 (R-ch)
+ �
1. Connect a distortion meter to TP11 (L-ch) and TP9 (R-ch) on the RX board. 2. Adjust L34 and 35 for L-ch and L54 and 55 for R-ch on the RX board so that the reading on the distortion meter is minimized.
�6�
|
|
 |
> |
|