|
|
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
Good manual. Even it is an old printed manual, it is well scanned and complete, with all drawings, schematics and parts list. Very good return for the cost.
;
I'm very satisfied with my purchase. It resolved my problem. Owner-manuals.com is a very very good place.
Thank you!
 ;
Veramente completo, dettagliato e perfetto nella visione. Perfect, thanks!
;
Fully functional usable service manual. Considering the age of the manual and device quality was better than expected
;
Thank you very much, I've been very happy to find this manual on "Owner Manual". It's a perfect copy and it has been really useful for my work!
TEST MODE
Test Mode has a �Manufacture Mode� for checking the movement. It decides to become �Manufacture Mode� if the TEST pin is a �L� level when the MCU starts from reset. <Triggering method of the Test Mode> 1) Short the Test-Pin and GND-Pin. TAKE NOTE: Refer to Page 6 �WIRING � 1 (MAIN)� Map Location (G11) for the actual position of the shorting point.
2) Turn on the power supply of the set.
� Manufacture Mode
This Mode can check the LCD display, Key, Switch and various IC. All the LCD Display is turned on for five seconds from reset start. The EL Backlight is tuned on until the Key is pressed from reset start. After that, Dot matrix: Show �Manufacture Mode� Pictograph: Repeat Mark .... When USB cable is connected: ON When USB cable is disconnected: OFF POP Mark ........ When MMC is inserted: ON When MMC is pulled out: OFF ROCK Mark .... When HOLD switch is ON: ON When HOLD switch is OFF: OFF Others .............. OFF �Battery Mark indicates voltage value�
� Display and Movement
MENU can be chosen when the MENU/LIGHT key is pressed. Following is the �Turn�: 1) KEY CHECK -----> 2) USB CHECK -----> 3) FLASH CHECK -----> 4) MMC CHECK -----> 5) DSP CHECK 1) KEY CHECK Display indicates the name of Key while the Key is kept pressing. MENU/LIGHT Key is checked by Menu change. 2) USB CHECK When the set is connected to the PC, if it recognize the set, check is OK. Display indicates �CONNECT� and when USB cable is connected all keys are useless. Please check USB by menu of USB CHECK only. 3) FLASH CHECK If the flash memory can be formatted, check is OK. 4) MMC CHECK If the MMC can be formatted, check is OK. If �VOLUME +� Key (Y) is pressed when MMC was pulled out, MMC cannot be formatted. 5) DSP CHECK If MCU can communicate with DSP, check is OK.
� 20 �
|
|
|
> |
|
