|
|
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
This manual is very good. 303 pages scanned in a very high resolution. My camera has bad, leaking capacitors which all of the V5000 models are suffering from these days.
There is a huge part list with all capacitors, transistors etc. in this manual which helped me a lot. Otherwise I would not have been able to buy replacement parts.
The dissassembly guide is very enormous and detailed. Unlike on the Panasonic MS1 manual I downloaded here it actually looks like the real parts look. And the screws are labeled correctly, so you shouldn't have any left after the repair. ;)
;
has all the schematics you could need,and very well laid out format also has all part numbers along with an exploded view which is helpful
 ;
Very nice to have! Now it is no problem to understand how it is put together.
Helps me a lot.
;
good scans, all is clear. all pages in order. recommended
;
Très-très bon site, facile, très bon prix.
Au futur besoin, je n’hésiterais à faire appel à vous.
Merci
MX-K50R
Disassembly method
Removing the metal cover (See Fig.1)
1. Remove the three screws A attaching the metal cover on the back of the body. 2. Remove the six screws B attaching the metal cover on both sides of the body. 3. Remove the metal cover from the body by lifting the rear part of the cover. ONE POINT How to eject the CD tray (see fig.2) Although it will end if the OPEN/CLOSE button is pushed when a power supply can be taken, when that is not right, CD tray will be opened manually. Turn the loading pulley gear at the bottom of the CD changer unit as shown in Fig.2 and draw the CD tray toward the front.
Metal cover
A
B
(both sides)
Fig.1
Loading pulley gear (See <CD changer unit>fig.1)
Removing the CD tray fitting (See Fig. 3)
Prior to performing the following procedure, eject the CD tray. 1. After drawing the lower part of the tray fitting toward the front, remove the five claws. Then, while moving the tray fitting upward, remove it.
CD tray fitting
Fig.2
Joint
Removing the CD changer unit (See Fig.4 to 7)
Prior to performing the following procedure, remove the metal cover and CD tray fitting. 1. Remove the card wire attached to CD changer unit on the adhesion tape.
Claw
2. Disconnect the card wire from the connector CW105 on the CD board. 3. Disconnect the harness from the connector RCW6 on the main board and CW107 on the CD board.
Fig.3
Card wire
4. Remove the two screws C attaching the CD changer unit to the rear panel. 5. Remove the two screws D attaching the CD changer unit to both sides of the front panel assembly. 6. Draw the CD changer unit upward from behind while pulling the rear panel outward. 1-6
CD changer unit
Adhesion tape
Fig.4
|
|
|
> |
|
