|
|
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
Great product, helped me to restore vintage walkman cassette.
Just some pictures could be little bit more sharp and contrast
Thank you
;
I love older radio's and the service manuals that are sometimes hard to find. Was able to find a manual quite easily on this site.
;
Thank you for your shop manual! Your help was very useful - the device is repaired! Once again - Thank you! I wish you a successful business! Edward (Russia).
;
It was a great experience,instead of purchasing a new Stereo Amplifier ,in just minutes i repaired my old one and that was thaks to the manual I have purchased from you.
Thanks again.
Samuel Alter
;
Das ging ja sehr unkompliziert hat bestens geklappt und die Quallität ist auch noch gut.
Vielen Dank dafür.
Page: 142
Service Guide OJ2010
Chapter 4 Failure and Repair Analysis
4.8.05 End of Forms Sensor Test
This test checks the operation of the end of forms sensor on the sensor board. 1. Power OFF the unit. 2. Move the two pin jumper on connector J13 of the system board to the position shown below.
3. Power ON the unit. 4. Check the sensor by performing either of the steps listed below. -- Activate the end of forms flag. -- Place a piece of paper in the manual feed slot.
5. The power light should go on and off as the flag moves past the sensor. If it does not, replace the system board. 6. Power OFF the unit to end the test. 7. Return the jumper to its original pin position after completing the test.
Copyright 1997, Okidata, Division of OKI America, Inc. All rights reserved. See the OKIDATA Business Partner Exchange (BPX) for any updates to this material. (http://bpx.okidata.com)
|
|
|
> |
|
