|
|
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
Great Manual! It contains all the wiring schematics and mechanical exploded views that are essential for service and repair. I was surprised I even found this for such an old machine. Only wish I knew of this site many years ago.
;
Great manual very clear copied. You are making an incredible job. I appreciate a lot the rapidity and your efficiency. Thanks a lot
;
Good pdf of the service manual for this unit. Includes disassembly instructions, full schematics, board layouts, parts lists and diagnostic information. Some information is in the pdf twice (single pages, and split pages), but that could be how it was originally generated by panasonic, or perhaps the idea is to make it eaiser to put onto 8.5 x 11" pages.
Information was exactly what I needed. Delivery was overnight (less than 12 hours) and I was happy with the process.
;
5 STARS for FAST DELIVERY, BEST PRICES and QUALITY PRODUCT. Item was exactly as described with superb resolution. Will definitely source all my future requirements from this website. Thanks a lot owner-manual.com!
;
OEM manual provided all schematics, board layouts and component specs necessary to facilitate unit maintenance. All pages were clear and readable.
Speaker System: PDP-S02-LR
4.6.2 Mounting to the main unit
Two mounting methods are available. Proceed as follows. 1 Mounting to the sides of the display � The figure illustrates how to mount the speaker to the right side of the display.
[PDP-502] [PDP-501MX/PDP-V501X]
2 Mounting using commercially-available mounting components � This speaker system comes with M8 washers (ø25) for mounting the system using commercially-available mounting components. � Use either the center set of two mount openings or the lower set, which is designed for use with commercially-available mounting components. The two mount openings for either set are not level; the supplied washer provides the necessary compensation.
UP
UP
Cushion Mount components
UP
Secure at either pair of points, with the washer Flat screw Washer, M8 (ø25) Hole rivet Washer (ø15) Hexagonal screw fitted to the lower opening to level it with the upper opening.
Connection to a stereo amplifier
1. Switch off power to the stereo amp. 2. Use the supplied speaker cable to connect the speaker input to the amp output. The red input terminal (the terminal at the right in the illustration) is positive (+). The black terminal (at the left in the illustration) is negative (�).
1. Remove the lower two hole rivets from the rear of the display. (The hole rivet can be removed using a coin or other device.) 2. Mount the supplied mounting components to the speakers. (Take care to keep the protective cushioning from peeling off.) 3. Find the left and right speakers (check for �Left� and �Right� marks) and mount the speakers to the display, with the cushioning facing the display and the �UP� mark up, by first tightening the lower, then the upper mounting components. (At this point, the mounting components are only tightened temporarily.) 4. Securely tighten the flat screws to mount the mounting components firmly to the display, while positioning mounting components to ensure even clearance between the speaker and the display. � The use of screws other than those supplied may prevent secure installation or correct operation. Use only the supplied mount screws. � If you must move the display after the speakers have been mounted, grasp the lower part of the display instead of the speakers.
1 Pare the insulation from the ends of the cable and twist the bare wires.
2 Press the level and insert the ends of the twisted wires into the proper openings. Release the lever. Negative · terminal Positive ª terminal
To negative · terminal
To positive ª terminal
(Output from the stereo amp)
55
|
|
|
> |
|
