SHARP PG-M10XU
Service Manual

PG-M10SU/SE PG-M10XU/XE 14)Lamp housing (See Fig. 15.) Remove the three screws (S-7) shown in Fig. 15, and detach the lamp housing from the bottom cover. Remove the screws (S-15) shown in Fig. 15, and detach the thermistor and thermistor plate. Remove the screw (S-7) shown in Fig. 15, and detach the ballast lock base. With the lamp housing taken out, the 40 fan assembly (DC) can be detached. Note: Take note of the wiring for the 40 fan assembly, which goes below the lamp housing.
40FAN(DC) S-7 Lamp housing S-15 Thermistor Ass�y S-7 Thermistor Plate S-15
Front Foot

16)Front and rear feet (See Fig. 17.) As shown in Fig. 17, press the hook (1) first and then the hook (2). Remove the front feet. Turn the rear feet away out of place. Remove the screw (S-7) shown in Fig. 17, and detach the lamp limit switch.

S-7 Lamp Limit Switch Rear Foot

Fig. 17

Fig. 15 15)Power unit (See Fig. 16.) Remove the two screws (S-7) shown in Fig. 16, and detach the fan base from the cover. Remove the screws (S-5 and S-10 one each) and the two D/M spacers shown in Fig. 16, and detach the power unit.
S-5 S-10 D/M Spacer

40FAN(L) S-7 Power Unit

S-7 Fan Base

Fig. 16

14