Bought T4850 High End Tuner a few years ago, but i didn't know where all the buttons were used for. So i purchased the owners manual. Perfect! Just what i needed.
Bought the used Philips car-radio. No manual! Found on this site a copy of the orginal English manual. I am very happy with it. Now I know how to setup and use my "new" car-radio.
Recommended site for everybody looking for a manual for (older) products!
The only reason I gave this less than 4 stars, is because it shouldn't take 24 hrs to have the download available. I was surprised to find that I had to wait until the next day to be able to download the manual that I paid for.
The manual itself is the correct manual.
Text excerpt from page 8 (click to view)
ELECTRICAL CONNECTION
The appliance is predisposed to function with a 230V monophase voltage tension. Connection must be carried out in conformity with the regulations and dispositions of the laws in force. Before connecting ensure that: - The limiter valve and the electrical mains can support the voltage of the appliance (see registration plate). - The power supply is correctly earthed according to the regulations in force. - The plug or omnipolar interrupter used can be easily reached once the appliance has been installed. Fit the cable with a plug suitable to the voltage and connect to an appropriate security socket. If a direct connection to the mains is required, an omnipolar interrupter with a minimum opening of 3mm between contacts, dimensioned to the voltage and corresponding to the regulations in force, should be interposed between the appliance and the supply. The yellow/green earth cable must not be interrupted by the interrupter. The brown coloured phase cable (situated at terminal �L� of the terminal box) must always be connected to the network phase. The voltage cable must always be positioned in such a manner that it at no point reaches a temperature of 50�C above room temperature. An example of the best routing is shown in fig. 3. The cable is guided by use of clamps fixed laterally to the unit in such a way as to avoid any contact with the appliance under the hob.
CLAMPS
YES
RIGID METALLIC TUBE OR FLEXIBLE STAINLESS STEEL TUBE
Openings in the Forniture Unit
{
REAR VIEW
NO
REAR VIEW
FO 0238-EN Fig. 3
In case of substitution of the voltage cable use cable type H05 RRF having a section suited to the charge, it is furthermore necessary that the yellow/green earth wire be approximately 2cm longer than the phase and neutral wires (Fig. 4). After connection try out the heating elements allowing them to function for approximately 3 minutes.
FO 0073-EN
Fig. 4
The manufacturer declines all responsibility in case the prevention of accidents regulations are not respected.
