|
There are currently no product reviews.
 ;
Excellent transaction - clean document received - Thanks a lot
;
Manual is in German but complete. I needed this one to fix a long lasting problem with the internal PSU of the camera. Most of the capacitors begin to leak after a few years wich results in the inability to power on the camera. When you try to turn it on the power led flickers and the unit directly turns off. Thanks to this manual I was able to locate all bad cap's and to dis- and reassemble the camera without any problems.
 ;
We received the manual in a timely manner and it was exactly what we were expecting.
;
Excellant, finally this is want I need and searching for The service manual is fantastic and thank you to owner-manuals.com and its service. Price is reasonable. It's a bit slow on my end in downloading but manage to receive the whole manual without a break. once again, thanks.
;
Very good scanning quality. All schematics are very legible. Worth every cent !
1
2
3
4
- Bonding Position
A
Make come near C888 and C887 and them apply bond from the top. 35 pts : GEM1017 3 pts : GYL1006
Hold here.
B
Hold here.
C
D
2 : Apply bond : the bond must not flow into screw hole.(C8,C9)
3 pts BOND LOCK 35 pts Capacitor
Press the thermistor against the transformer and apply an adhesive as the end of the thermistor touches the transformer.
Adhesive
E
Press
*Bond should be applied both of parts and PCB. *Be aware not to apply bond on contact point of connector, seat area of screw.
* TACK-FREE TIME 10 minutes
* TACK-FREE TIME 5 minutes
Note) When applying bond to two Film Capacitors (C887 and C888) , attach them and apply bond.
F
16
PRS-D1200SPL/XU/UC
1 2 3 4
|
