|
|
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
Although printing quality is not the best, the manual was very helpful in order to reactivate this ancient but still good electronic musical instrument.
 ;
as a first-time user and buyer from this site, i found the overall service outstanding!! this product is a godsend as, without it, i would never have been able to find my way around and use my machine as intended. i will certainly use this site again as required. many many thanx!!
 ;
This manual is exactly what I needed. This site always has every manual I need, and it is also much less expensive then most other sites. This is the only manual site I will use.
 ;
Useful manual, good scan, worth the pay if you find the unit difficult to operate.
 ;
Exactly as described, the full user-manual (145 pages). Perfect.
� Withstands high SPLs lending itself to a wide range of miking situations � Ultra sensitive element picks up all of the nuances of any performance � Accepts a wide variety of phantom power source voltages from 11 to 52 Vdc
Microphone Placement and Tone Quality Listed are some common microphone placement techniques. Use these suggestions as a guide and let your ears determine what works best in your situation. � Sound source less than 6 inches away from mic�Full sound, pronounced bass, increased isolation from background noise. � Sound source 6 inches to 2 feet away from mic.�Balanced natural sound, less bass, some background noise. � Sound source 3 to 6 feet away. from mic�Thinner ambient sound.
Guidelines for Microphone Use � Aim the microphone at the desired source. Keep unwanted sound sources at a 135° angle from the front of the microphone (see polar pattern). � Place the microphone as close to the sound source as possible. � Use the proximity effect to your advantage. The closer the mic is to the sound source, the more emphasized the bass response will be. � Use a windscreen to suppress unwanted wind noise. � Never cup your hand over the microphone grill.
Operating Notes � The Q1 requires phantom power to operate. This is supplied to the microphone via the XLR cable when connected to preamplifiers, mixers, or consoles with built-in phantom power. The Q1 will operate with phantom power sources between 11 to 52 Vdc. � The Q1 will boost bass frequencies when the microphone is between 0�6 inches from the sound source. As you move the sound source further away from the microphone, the bass response will gradually roll off. � The Q1 has a built-in wind screen which protects against most wind and breathing noise. Under adverse conditions, such as high winds, an optional foam windscreen can be used. � For maximum signal handling capability and minimal distortion, a minimum load impedance of 800 ohms should be used. A reduction in output signal strength and output clipping level will result with the load at 150 ohms.
|
|
 |
> |
|