WHIRLPOOL R61
Owner's Manual

Operating Continued

Instructions

2. To circulate room air: l Set Exhaust Control to CLOSED. l For cooling, set System Control to desired fan speed. l If no cooling is desired, set System Control to FAN ONLY (on some models). If there is no FAN ONLY setting, select a fan speed setting and set Thermostat Control to its lowest setting. Be sure to reset Thermostat Control when cooling action is desired. NOTE: For maximum performance, the Exhaust Control must be in the CLOSED position when cooling, or room air circulation is desired.
Svstem c&trol

Thesome models) settings SAVER (on ENERGY
The ENERGY SAVER settings are the three settings to the bottom of the System Control (HI, MED and LO). These settings save energy. The fan will cycle on and off as the Thermostat Control turns the compressor on and off. This saves the cost of electrical energy that would be used to run the fan continuously. It is normal for the fan to turn on and off in the ENERGY SAVER settings. The amount of time the unit will be off depends on the room temperature and Thermostat Control setting.

Changingair direction
Tab

The louvers, in the top grille area of the air conditioner, control the direction of the cooled air. Move the tab, at the top of the louvered area, in the direction you want the air to go (right, left or straight ahead).