|
|
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
Acurate informations inside the SM and I could repair my old Sansui SC-3330 without any problems. Thanks.
;
I used it to repair a NAD 7030, but unfortunately, the 7045 is different !
But documentation was useful.
;
Content A4 and A3 format pages. Exactly what I needed to restore my old receiver.
;
Content A4 and A3 format pages. Exactly what I needed to restore my old receiver.
;
Thanks you very much for this "hard to find" service manual.
Will help a lot in repairing this receiver.
RD-VH7
CD MECHANISM DESCRIPTION
The initialization position of mechanism is the slider(loading) 1 position at the back most. The mechanism moves from this position.
1. 8cm DISC loading in
1) Insert a disc î Check by a disc detection sensor2 (prism reflection ray OFF) î Start loading motor3 î Move the roller4 î Pull in a disc 2) Push the shaft of the arm assy (trigger A )5 with a disc î Move the arm assy(trigger B)6 î Move the arm (trigger)7 This time, decide PLAY position of a disc by the stoppers (shaft) of the arm assy(L )8 and the arm assy (R )9. 3) Move the arm (trigger)7 î Push out the slider (loading)1for front î Move the gear(final)0 î Move the slider (loading)1 for this side î Loading down the clamper of sub chassis- and the roller4 î Finish a disc catching 4) Move the slider (loading)1 for this side î Move the slider (disc guide)= for right direction î Came off the moved lock of the arm assy (lock)~ î Move the arm assy (L)8 and the arm assy (R)9 î Keep off the stoppers from a disc. î Move the slider(loading)1 for this side î Turn on the switch ! î PLAY a disc
8
9
5
6
7
Note: Set the loading slider to full backward if reinstall it.
1
10 11
4
5
1
3 4
2
12
12
|
|
|
> |
|
