|
|
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
Hi, thankyou for providing the Nordmende Globetrotter original manufacturer's repair manual. Quality is very good and sharp - the PDF file was comfortably small to download. The only question is: why did it take so long to become ready for download?? Many thanks anyway, I fixed the fault in the radio thanks to the circuit.
regards: Nick
 ;
This was super service.Ordered this manual and was reading the download an hour later
;
as always, rapid and efficient, very good and clear prints
details clearly visible keep going this way!!!!!!
;
I expect a wonderful result as alaways!!!!!!
Usually is much faster....
;
Wow very wonderful and clear!!!! I will always trust them
ORDER NO.
RRV2042
SPEAKER SYSTEM
S-A555
S-A550
XE
FOR PRECAUTION OF REASSEMBLY AND DISASSEMBLY
The cosmetic baffle is attached to the baffle by its bosses and press-fitting. To detach it, pry it open by inserting a flat blade screwdriver into the cosmetic baffle lower side. Be careful not to damage the cosmetic baffle and cabinet in this case. The woofer is attached to the baffle by 4 external screws. To detach it, first remove the cosmetic baffle. Next unfasten those screws. Then remove the woofer. When attaching it, face its terminal downward. The tweeter is attached to the spacer by inserting. To detach it, first remove the cosmetic baffle. Next pull it off the spacer. Then remove the tweeter. When attaching it, insert the tweeter in the spacer.
XE
These products are components of system. For the operating instructions, refer to the service manual RRV2047 for XR-A660, XR-A550.
The midrange, together with the spacer, is attached to the baffle by 2 external screws. To detach it, first remove the cosmetic baffle. Next unfasten those screws and pull the midrange and the spacer off. Then remove the midrange and the spacer. When attaching it, first fit the boss into the hollow on the spacer. Next the left one, face its terminal lower right. Then the right one, face its terminal lower left. When attaching the spacer, fit the boss into the hole on the baffle. Then fasten the midrange and the spacer together.
PIONEER ELECTRONIC CORPORATION
4-1, Meguro 1-Chome, Meguro-ku, Tokyo 153-8654, Japan PIONEER ELECTRONICS SERVICE, INC. P.O. Box 1760, Long Beach, CA 90801-1760, U.S.A. PIONEER ELECTRONIC (EUROPE) N.V. Haven 1087, Keetberglaan 1, 9120 Melsele, Belgium PIONEER ELECTRONICS ASIACENTRE PTE. LTD. 253 Alexandra Road, #04-01, Singapore 159936
PIONEER ELECTRONIC CORPORATION 1998
T-ZZW OCT. 1998 Printed in Japan
|
|
|
> |
|
