PANASONIC SLPD7
Owner's Manual

A

Example: Recording from a disc containing seven tracks onto a 60-minute tape. Silent interval between tracks (approx. 4 seconds) Side A (30 min) Track 1 Track 2 Track 3 Track 4

Edit guide function
A When recording, the changer will automatically program the tracks for tape sides A and B in accordance with the length of the tape so that none of the tracks will be interrupted before they are completed. In addition, the program will also include a silent interval of approximately 4 seconds between tracks.

Side B (30 min) Track 5 Track 6 Track 7

1 2
,

Press [DISC SKIP] to select the disc to be recorded. Prepare the tape deck for recording.
Set the Dolby NR, reverse mode, recording level, etc., as instructed in the Operating Instructions for the tape deck. Note Rewind the tape so recording is possible from its beginning.

POWER

SPIRAL

RANDOM MODE

REPEAT

1 4

2 5 8 0

3 6 9 10
OPEN CLOSE

3

Press [EDIT GUIDE] to select the tape length.
Each time you press the button, the display showing the tape length changes as follows. C-46 C-60 C-90 C--Choose the length of the tape you will use.

/I

ID SCAN

EDIT GUIDE
DISC 1 DISC 2 DISC 3 DISC 4 DISC 5 DISC SKIP

7 10

TIME MODE

PROGRAM MODE

3 1
SL-PD9
DISC SKIP

1
SL-PD7A
DISC SKIP

4

More precise time settings are also possible. (Refer to �To enter a desired recording time other than 46, 60 or 90 minutes� below.) The data of the tracks to be recorded is displayed as shown in the diagram. In this example, disc 5 can be recorded with tracks 1-4 on side A and tracks 5-7 on side B of the cassette tape.

Specified disc number

4
DISC TRACK MIN SEC

Start recording on the tape deck and then immediately:

Press [ ].
When the last track set for recording on side A is finished, the changer will enter the pause mode. Set the tape to the position from which recording will begin on side B, and then perform step 4 once again. When all the programmed tracks on the specified disc finish playing, the changer will automatically stop. The edit guide mode will be cancelled at the same time.

...................................................

3

EDIT GUIDE
DISC MIN

EDIT

Side A

Number of tracks Tracks to be to be recorded recorded

To enter a desired recording time other than 46, 60 or 90 minutes
1. Select �C---� in step 3 . 2. Enter the total recording time in minutes (1-99) using the numeric buttons. For example To use 52-minute tape, press [5] then [2]. You can also specify the tape length by pressing [ ] or [ ] buttons. Press either [ ] or [ ] from each step C-46, C-60, C-90 or C---. For example To use 52-minute tape, select C-46 and then press and hold [ ] until the display shows �52�. The maximum allowable playing time for editing is 99 minutes.

TRACK

EDIT

Remaining time on side A

MIN

SEC

EDIT

Side B

Number of tracks Tracks to be to be recorded recorded

TRACK

To stop recording
EDIT

Press [ deck.

] and then press the stop button on the tape

Remaining time on side B Note Depending on the disc, a little of the beginning of the next track may be recorded onto the end of the track.

MIN

SEC

EDIT

...................................................

4

13
RQT5763

Operations