|
|
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
Excellent copies.
I will use "Owner Manual" again a second time.
 ;
Very good manual for Technics SL 303. Manuale molto utile.
;
About one hour after checkout, the manual was available for download. Clear reading and detailed. Thanks
;
Excellent transaction - clean document received - Thanks a lot
;
Manual is in German but complete. I needed this one to fix a long lasting problem with the internal PSU of the camera. Most of the capacitors begin to leak after a few years wich results in the inability to power on the camera. When you try to turn it on the power led flickers and the unit directly turns off. Thanks to this manual I was able to locate all bad cap's and to dis- and reassemble the camera without any problems.
3-2. HANDSET
[Setting the Test Mode] Power on with press the * key and the # key simultaneously for one second, and the Test Mode is set. * Press the SPEED DIAL key (SPP-ID300) or INTERCOM key (SPP-ID400) in Test Mode, EEPROM (IC501) is been initialize, and it beeps confirm tone. * LIQUID CRYSTAL DISPLAY turns on/off, when press the # key. [Releasing the Test Mode] To release the Test Mode, perfome as follows: � Press the TALK key or REDIAL/PAUSE key. � Turn off the power (disconnect and reconnect Battery connector). � Set the haundset to charge on the base unit (except Test Mode 10). [Changing the Test Mode step] Press the each key of the Test Mode No. [Changing the Channel] Press the CHANNEL key. * The channel is back to initial channel (6 CH), when Test Mode step is changed. � Channel Rotation
6 CH
18 CH 5 CH 16 CH
1 CH 7 CH 17 CH
10 CH 8 CH 19 CH
11 CH 9 CH 20 CH
25 CH 12 CH 21 CH
2 CH 13 CH 22 CH
3 CH 14 CH 23 CH
4 CH 15 CH 24 CH
� 21 �
|
|
|
> |
|
|
Parse Time: 0.194 - Number of Queries: 102 - Query Time: 0.049
