|
|
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
Product was very good. Received quickly and complete
 ;
Although printing quality is not the best, the manual was very helpful in order to reactivate this ancient but still good electronic musical instrument.
;
as a first-time user and buyer from this site, i found the overall service outstanding!! this product is a godsend as, without it, i would never have been able to find my way around and use my machine as intended. i will certainly use this site again as required. many many thanx!!
;
This manual is exactly what I needed. This site always has every manual I need, and it is also much less expensive then most other sites. This is the only manual site I will use.
;
Useful manual, good scan, worth the pay if you find the unit difficult to operate.
Performing initial setup operations
Once you have hooked up the speakers and turned on the power, clear the receiver�s memory. Then specify the speaker parameters (size, position, etc.) and perform any other initial setup operations necessary for your system.
Tip
Performing initial setup operations
Before using your receiver for the first time, adjust SET UP parameters so that the receiver correspond to your system. For the adjustable parameters, see the table on page 66. See pages 20�25 for speaker settings.
Multi channel surround setup
For the best possible surround sound, all speakers should be the same distance from the listening position (A). However, the receiver lets you to place the center speaker up to 1.5 meters (5 feet) closer (B), the surround speakers up to 4.5 meters (15 feet) closer (C) and the surround back speakers up to 4.5 meters (15 feet) closer (D) to the listening position. The front speakers can be placed from 1.0 to 12.0 meters (3 to 40 feet) from the listening position (A). You can place the surround speakers either behind you or to the side, depending on the shape of your room (etc.).
continued
To check the audio output during settings (to set up while outputting the sound), check the connection (page 25).
Clearing the receiver�s memory
Before using your receiver for the first time, or when you want to clear the receiver�s memory, do the following.
1 Turn off the receiver. 2 Hold down ?/1 for 5 seconds.
�MEMORY CLEARING�, then �MEMORY CLEARED� appears in the display and all of the following items are reset or cleared: � All preset stations are reset or cleared. � All sound field parameters are reset to their factory settings. � All index names (of preset stations and program sources) are cleared. � All SET UP and CUSTOMIZE parameters are reset to their factory settings. � The sound field memorized for each program source and preset stations are cleared. � The master volume is set to VOLUME MIN.
19US
Hooking Up and Setting Up the Speaker System
|
|
|
> |
|
