My first manual from Owner-Manuals.com but not the last! I am very satisfied with the easy ordering and promt delivery of a manual I did not find anywhere else.
This manual is very helpfull to use the Power Supply. All technical information has been available.
For service use the circuit diagrams are very good.
Thanks .
Very comprehensive document which is a must-have for any Satellit 2100 owner whose set up is somewhat intricate. Due to the bad quality of the pictures that are rather dark and a bit blurred I gave 4-star feedback.
The manual was missing 2 pages but when I presented the problem to the company they made every attempt to get the 2 pages to me, when they couldn't they refunded my money. A very pleasing and easy transaction. The manual they provided was the original, it was concise and to the point. I plan to do business with this company again when should the need arise.
Text excerpt from page 19 (click to view)
Adjusting the level of the received audio signal
You can adjust the level of the received audio signal (e.g. the voice of the speaker) in 64 steps. Use the / rocker button (UP/DOWN) to adjust the level of the received audio signal so that you can hear the speaker loud and clear.
Adjusting the level of the internal microphone
You can adjust the level of the internal microphone (via which you can hear environmental sounds) in 64 steps. Press the SET button Use the level. / . The current level is displayed. to adjust a comfortable rocker button (UP/DOWN)
Note: You can only adjust the level of the internal microphone when the internal microphone is switched on in the receiver�s configuration. If, in addition, the automatic priority circuit is switched on, the internal microphone is faded out as soon as speech is being transmitted.
Switching the channel
You can only switch between the released channels. This can be necessary when the selected channel is subject to interference. Always set the receiver to the same channel as the transmitter. If interference occurs, check if the same frequency is assigned to the same channel on both transmitter and receiver. Press the SET button and keep it pressed for approx. five seconds. The current channel is displayed. Use the / rocker button (UP/DOWN) to select a channel.