|
|
|
Who's Online
There currently are 5800 guests online. |
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
Excellent manual - just what I needed. Although currently available only in German, their are lots of pictures which makes it all very clear.
;
PHILIPS PE1642 Owner's Manual
Hi,
you have complet fullfilled my expectance.
Price is OK.
Robert Schmid
 ;
Came in the mail within a few hours. Gave clear instruktion on maintaines. Is of great use to have this manual in house
;
Easy to access. Clear instructions. No problems. Printed fine.
;
Great scan but please note that it is entirely in GERMAN.
SETTING UP
Setting the Video Channel
This VCR is designed to send picture and sound signal on UHF channel 38 (597.25 MHz) to the TV, through the RF coaxial cable. For customers in Australia; If you want to change this video channel (38) to another channel (between 28 to 60), follow the procedure below before turning on the VCR for the first time. For customers in New Zealand; Be sure to set video channel (between 28 to 60) by following the procedure below before turning on the VCR for the first time.
1 Make sure the VCR is turned off and no cassette inserted. 2 Turn on the TV, and tune it to any channel (UHF 28 to 60) you want to use as the video channel on the TV.
� Select a channel not used in your area.
3 Press STOP/EJECT 7 /0 on the front panel for more than 5 seconds.
The following indication appears on the display.
TV system number starts flashing.
4 Press CH 5 / � on the front panel to select an appropriate TV system number for your area.
1. For B/G. (For West Europe, ASEAN countries, New Zealand) 2. For D/K. (For China, Russia, East Europe) 3. For I. (For Hong Kong, South Africa, United Kingdom) 4. For H. (For Australia) 5. For M. (For USA, Canada, Mexico, Japan, Latin America Countries, Korea, Taiwan, Philippines) Press OK/STATUS. The channel number starts flashing on the display.
5
Channel number starts flashing.
6 Press CH 5 / � on the VCR to select the channel you have tuned on the TV as the video channel in step 2.
A test signal (two vertical white bars) appears on the TV.
If you use only external video input (AV) mode to watch the picture from this VCR, you can turn off the video channel output. To turn off the video output channel, press CH � until �� �� appears on the channel number position.
Test signal (two vertical white bars)
7 Press
OK/STATUS to finish the video channel setting. Now you will enter the Initial Setup mode explained on page 9.
To watch a picture from this VCR on the TV, select the same channel you have selected as the video channel (in step 2 above) on the TV.
�9�
vr1010/75 9 00.6.29, 4:53 PM
|
|
|
> |
|
