SHARP VR-PK50E
Owner's Manual

CONTENTS

PREVIOUS PAGE

NEXT PAGE

Capturing images

7

4

Use the mode select buttons to choose the mode. � Click to capture images being displayed on the LCD screen of the VIEWCAM. � Click to capture images recorded on a tape as the tape is playing. Use the edge smoothing AUTO or OFF button to select whether or not to correct the image to be captured. � When edge smoothing AUTO is selected, images are automatically corrected when they are captured from the VIEWCAM. We recommend normally selecting this. � When edge smoothing OFF is selected, images are not corrected when they are captured from the VIEWCAM.
Note
On VIEWCAMS which automatically perform edge smoothing on images, the images are captured with the edge smoothened without having to set this button.

Click when the image you want to capture is displayed. � The image stops moving (a still image is displayed) and transfer from the VIEWCAM begins. � The save folder selection dialog box shown below is displayed when transfer is completed.

5

6

Start to view, record or playback the tape on the VIEWCAM to display images on its LCD screen. � When capturing images being displayed on the LCD screen, the zoom buttons (Camera mode) can be used to enlarge or reduce the image you want to capture. � When capturing images being played, use the control buttons (VCR mode) to display the image you want to capture.

� When the image capture has been completed, the VIEWCAM returns to the status prior to the image capture. (Example: When the is clicked during playback, the playback will stop until the image receiving has been completed, and then continue after.)

4