|
|
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
I'm very happy that you all are performing an incredible good job. Furthermore what you did is very useful for all people as me that have electronics as an hobby.Thank you!!!!!
;
Manual found fast and good quality, very helpfull service
;
8-17-12 Been using the sight for about 6 months. Fast Downloads and top quality
Manuels !
 ;
Everything was great, the manual, the response time, the simplicity of the order, and the
Price. The only thing that I could possible say on a negative note would be that the manual I ordered was more for a service tech. There were a lot of schematic diagrams that didn't help me solve the problem. However I would order again and recommend the web sight to others.
;
I'd been looking for this manual for awhile. Exactly what I needed - and at an excellant price. Thanks!
FACTORY & ELECTRONIC ADJUSTMENT
VER1.0
C. Select B-GAIN and adjust the B-GAIN value until y = 343±30 D. Repeat steps A, B and C until the following final values are obtained: x = 335±30 y = 343±30 Y = 30±1 FL (5) Upon completion of Steps 3 and 4 above, press the FAV.SET key for the next Color Temperature setting (5400¡÷6500D¡÷9300¡÷13800). For each color temperature setting, please repeat Steps 3 and 4 above but replace the x and y settings with the following values: a. 6500D: x = 313, y = 329 for both Dark and Bright Level Settings b. 9300K: x = 285, y = 295 for both Dark and Bright Level Settings c. 13800K: x = 260, y = 275 for both Dark and Bright Level Settings For these 3 Color Temperatures (6500D, 9300K and 13800K), adjust the Dark and Bright Levels to the following Y values: a. Dark level Y = 0.4±0.1 FL b. Bright level Y = 30±1 FL (6) Once all 4 Color Temperatures have been adjusted, skip through the RGB and Component Color Temperatures (using the FAV.SET key) and completely exit the Factory Adjustment Menu. 2.1 Pre-setting Adjustment and Equipment Preparation for RGB Mode: (1) Turn on the Color Analyzer (Minolta, Model = CA-100) and reset the Color Analyzer. (2) Switch the PDP input to RGB mode and press the �Recall� key on the remote control to have the PDP set recalled back to default factory settings. (3) Set up the Video Pattern Generator (Chroma, Model = C2226) with the following settings: A. Timing: 640 x 480 @ 60Hz, B. Make sure the Output signal is Analog (RGB) Connect the PDP RGB input connector to the Chroma C-2226 RGB output connector. (4) Dark level and bright level center block definition: A. Dark level center block definition: Pattern set = Pattern name = 1-mosaic Color form = norm Background color = 0 Foreground color = 17 According to the C-2226�s user manual, appendix analog-color: Normal Pen from Pen 17 = R: 102, G: 102, B: 102 102 (output amplifier)/1024 (total amplifier)=10%, therefore the 10% is the 10 IRE white output pattern.
3-4
|
|
|
> |
|
