SHARP XEA202
Service Manual

7. DRAWER
[OUTLINE]
� Standard equipment: Yes (1) � Max. number of additional drawers: 0 � The drawer consists of: 1) Drawer box (outer case) and drawer 2) Money case 3) Lock (attached to the drawer)

8. BATTERY
1) MEMORY BACK UP BATTERY
For memory back up, the dry battery AA (3 pieces) are needed. 1. Memory holding time: Approx. 1 year after New dry batteries are installed. 2. Battery exchange method:

o

When the low battery symbol �L� lights up, replace the batteries (3 AA) by the following method; 1) Power on the ECR. 2) Mode switch turn to �REG� mode.

[SPECIFICATION] 1) DRAWER BOX AND DRAWER
Model name of the drawer box Size Material Bell Release lever Drawer open sensor SJ-420

n l o

3) Remove the OLD dry batteries (3 pieces). 4) Insert the NEW dry batteries (3 pieces). 5) Confirm the low battery symbol �L� is off.

2) LOW BATTERY
Low battery indication will appear on the left side of display when the battery voltage is low. CASE 1: When any numeric entry & any item entry is not done or just after finalization. The machine can indicate the low battery condition. (Always) CASE 2: When numeric entry or item entry is done.

355 (W) x 424 (D) x 125 (H) mm Metal � Standard equipment: situated at the bottom Yes

2) MONEY CASE
Separation from the drawer Separation of the bill compartments from the coin compartments Bill separator Number of compartments Layout: Allowed Allowed � 5B/8C

Battery condition will not appear. Exceptionally, when the power is restored after a power failure, the low battery condition will appear on the display only when the battery is low. And the indicator will disappear after any key entry. [Display sample] � �L �L 0.00� : Battery is OK. 0.00� : Low battery (You have to change the batteries.) 0.00� : No battery (You have to change the batteries immediately.)

After finalization �F �L �L 12.34� : Battery is OK. 12.34� : Low battery. (�L� indicate instead of �F�.) 12.34� : No battery. (�L� indicate instead of �F�.)

5B/8C

Note: �NO BATTERY�: When the �NO BATTERY� is display, the master reset is executed at the timing of �POWER ON� after the �POWER OFF�.

3) LOCK (LOCK KEY : LKGIM7331BHZZ)
� Location of the lock:Front � Method of locking and unlocking: To lock, insert the drawer lock key into the lock and turn it 90 degrees counter clockwise. To unlock, insert the drawer lock key and turn it 90 degrees clockwise. � Key No: SK1-1

ck
SK1-1

ck
u

L

XE-A202V

SPECIFICATIONS

�4�