|
|
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
Thank you very much for the manual. It is what I needed and it will be very helpful to me. The delivery of the manual was easy and very fast. I strongly recommend this site to other users. Best regards.
 ;
Excellent!! Got what I need and very fast!! Thank You
;
Manual acquired with good resolution, complete in all its pages, very good policy of the folder where are saved all products purchased.
;
Service manual very complete and clear. It was very helpfull for my work.
;
This is the 2nd time I download manuals from this website and I can say it's what I was expecting. It contains schematic, layout (decent quality), short description, parts and dissasembly instructions. I recomend it for anyone who wants to repair/modify this device.
1
2
3
4
A
2 DVD Error Rate Adjustment
Notes: · Use disc: GGV1025
· Play the DVD test disc at inner track (around #30000)
START
· Play the DVD test disc at inner track · Display ERROR RATE on the monitor
B
ESC CHP/TIM
G N
Traverse Mechanism Assy-S Adjust the radial adjustment screw so that ERROR RATE becomes around "5E-4". A ERROR RATE : "5E-4"
Traverse Mechanism Assy-S Fasten the radial adjustment screw so that ERROR RATE becomes around "1E-3". B ERROR RATE : "1E-3"
1E-3
ERROR RATE
C A A
B
5E-4
· Unfasten the radial adjustment screw by 90 degrees step till ERROR RATE becomes around "1E-3" again . C · Record the number of rotation (N1).
(memorizing how much the screw was rotated.)
Best point
C
Anticlock wise Clock wise Rotation of Radial screw and Tangential screw
· Fasten the radial adjustment screw till the number of rotation becomes harf of N1. Best Radial point
ERROR RATE: - - - -
ESC
Player Monitor
D
Service mode end
· Play the DVD test disc at outer track (around #200000) Service mode
ESC CHP/TIM
Turn the POWER OFF in case of NG once, and perform the adjustment once again.
If error rate is OK, locks a root of tangential and radial adjustment screws with
E
CHECK
OK
In this check, the error rate that is less than "5E-5"is better.
the Screw tight. Screw tight: GYL1001
Traverse Mechanism Assy-S Fasten the tangential adjustment screw so that ERROR RATE becomes around "1E-3". B ERROR RATE : "1E-3"
Disc playback normally. · The measurement of block error rate
ESC CHP/TIM
F
ESC
· Unfasten the tangential screw by 90 degrees step till ERROR RATE becomes around "1E-3" again . C · Record the number of rotation (N1).
Service mode end
· Fasten the tangential adjustment screw till the number of rotation becomes half of N1. Best tangential point
44
1 2
XV-DV370
3 4
|
|
|
> |
|
