|
Who's Online
There currently are 5796 guests online.
|
Categories
|
Information
|
Featured Product
|
|
|
|
|
There are currently no product reviews.
;
The manual was exact the thing that was promised. My old car stereo is working again thanks to the information supplied.
;
I PURHASED THIS PRODUCT BECAUSE I WAS HAVING PROBLEMS WITH MY CDR20 HARMAN KARDON RECORDER. WHICH I PURCHASED NEW 12 YEARS AGO. AFTER REVIEWING THE MANUAL, I WAS ABLE TO ADJUST THE TENSIONER IN THE SYSTEM. WORKS LIKE A CHAMP!.
SAVED ME AT LEAST 100.00 WHICH WAS WHAT A SERVICE REPAIR STATION WANTED. GREAT MANUAL EASY TO READ. SPECIALLY AFTER I PRINTED THE PAGES WHICH DEALT WITH MY RECORDER. THANKS A LOT!!!!!!!!
;
You can fully trust on this one!
All the schematics are very crear an in one piece per page
;
I have never bought a service manual which is as competely readable as this althogh it was a scanned pdf. Thank you for this succesful manual also cheaper than other sites.
;
Thanks for a very good and readable servicemanual. Just what I needed as a "dinosaur technician". I really recommmend this site and will come back.
Åsbjörn
x DTS Selects the DTS signals to be output via the DIGITAL OUT OPTICAL and COAXIAL connectors. You cannot select this item when you set �DIGITAL OUT� to �OFF.� � OFF: when the player is connected to an audio component lacking a built-in DTS decoder. � ON: when the player is connected to an audio component having a built-in DTS decoder. If the player is connected to an audio component lacking a built-in DTS decoder, do not set this. Otherwise, when you play the DTS sound track, a loud noise or no sound will come out from the speakers, affecting your ears or causing the speakers to be damaged.
Note
Select the setting correctly. Otherwise, no sound or a strange sound will come out from the speakers, affecting your ears or causing the speakers to be damaged.
Controlling your TV or AV Receiver (Amplifier) with the Supplied Remote Z
If you adjust the remote signal, you can control your TV or AV receiver (amplifier) with the supplied remote. Default setting is to control Sony TVs with the mark.
TV @/1
1 2 5 8 0 3 6 9
Number buttons
4 7
Controlling TVs or AV receivers (amplifiers) with the remote
Hold down TV @/1, and enter your TV�s or AV receiver�s manufacturer�s code (see the table) using the number buttons. Then release TV @/1. Code numbers of controllable TVs or AV receivers (amplifiers) If more than one code number is listed, try entering them one at a time until you find the one that works with your TV or AV receiver (amplifier).
Notes
� If you enter a new code number, the code number previously entered will be erased. � When you replace the batteries of the remote commander, the code number reset to 01 (Sony). Reset the appropriate code number.
Settings and Adjustments
53
|
|
|
> |
|