|
|
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
perfect! you just sent to me the copy in Italian witout even my specification!!!! so you are really smart cooperative and efficient. To my opinion the best place all over to get a manual of electronics!!!!
;
Well Well Well!!!! Good manual perfect for my hobby!!! As Before you have done a very well done work!!!! Thank you
;
Super nice! Good to have a manual in digital format.
;
Great job supplying the manual.
Many of these products weerepretty obscure, so it was great that you had
the manual for it!
;
Great manual, would not have been able to operate my machine without it!!
James Dawson August 18, 2012
Adjusting the Grip Strap 1
Open the hand strap flap (Q) and grip strap (W).
When recording, remove the lens cap (Q) and attach the lens cap cord to the fastener (W) so the lens cap will not get in the way.
Fastener
Preparation
2
Loosen the grip strap, pass your hand through the loop and put your thumb close to the Power Zoom control. Then pull the grip strap tight until it fits snugly.
Note: � Always replace the lens cap on the lens when the VIEWCAM is not in use.
Attaching the Shoulder Strap 1 2
Hold one end of the strap and thread it through the loop on the left side of the LCD screen. Loosen the strap in the buckle, then feed the end of the strap through the buckle, as shown. Draw the strap in the direction of the arrow to secure. Use the same procedure to attach the other end of the strap to the loop on the lens side.
3
Seal the velcro closure of the grip strap (Q) and close the hand strap flap (W).
3
4�6
1
4
Caution: � Do not swing the VIEWCAM by the hand strap.
2
5
Buckle
Using the Lens Cap
Attach the lens cap cord to the VIEWCAM as shown below (Q), and attach the lens cap to the lens (W).
Buckle
3
6
12
VL-SD20S-GB/pp. 008-016; 99/8/10/18:00 G. K . A s s o c i a t e s , To k y o
|
|
|
> |
|
